GE JSP39 Owner's Manual

Also see for JSP39: Use and care guide Installation instructions Use and care guide Owner's manual Installation instructions

GE JSP39 Owner's Manual Manual pdf 17 page image

17Safety Instructions Operating InstructionsSafety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportCare and cleaning of the range. www.GEAppliances.comBe sure all controls are off and all surfaces are cool before cleaning any part of the range.If your range is removed for cleaning, servicing or any reason, be sure the anti-tipdevice is re-engaged properly when the range is replaced. Failure to take thisprecaution could result in tipping of the range and cause injury.How to Remove Packaging TapeTo assure no damage is done to the finishof the product, the safest way to removethe adhesive left from packaging tape onnew appliances is an application of ahousehold liquid dishwashing detergent,mineral oil or cooking oil.Apply with a soft cloth and allow to soak.Wipe dry and then apply an appliancepolish to thoroughly clean and protectthe surface.NOTE: The plastic tape (on some models) mustbe removed from all chrome trim. It cannot beremoved if it is baked on.Oven Heating ElementsDo not clean the bake element or the broilelement. Any soil will burn off when theelements are heated.To clean the oven floor, gently liftthe bake element. Clean with warmsoapy water.Control KnobsThe control knobs may be removed for easiercleaning.To remove a knob, pull it straightoff the stem. If a knob is difficult toremove, place a towel or dishclothbetween the knob and control paneland pull gently. Wash the knobs in soapand water or a vinegar and hot watersolution.Before removing the knobs forcleaning, please note that the knobs arein the OFF position. When replacing theknobs, check the OFF position to ensureproper placement.Do not bend knobs by pulling themup or down or by hanging a towel orother such loads. This can damagethe shaft.To replace:Check the back of the knob.The molded rib of the knob isdesigned to fit perfectly onto theknob stem.Align the molded rib to the cleargroove in the knob stem. Push theknob back as far as it will go.Spring clipClear groovein stemMolded ribGroove StemControl PanelIt’s a good idea to wipe the control panelafter each use of the oven. Use a dampcloth to clean or rinse. For cleaning, usemild soap and water or a 50/50 solutionof vinegar and water. For rinsing, useclean water. Polish dry with a soft cloth.Do not use abrasive cleansers, strongliquid cleaners, plastic scouring pads oroven cleaners on the control panel—they will damage the finish.