GE JSP39 Owner's Manual

Also see for JSP39: Use and care guide Installation instructions Use and care guide Owner's manual Installation instructions

GE JSP39 Owner's Manual Manual pdf 6 page image

CONTROL LOCK/UNLOCKPRESS + AND – AND HOLD FOR 3 SECONDS6Oven Control, Clock and Timer Features and SettingsBAKE/TEMP RECALL PadTouch this pad to select the bake function.BAKE LightFlashes while in edit mode—you can changethe oven temperature at this point. Glowswhen the oven is in bake mode.START/ON PadMust be touched to start any cooking orcleaning function.DisplayShows the time of day, oven temperature,whether the oven is in the bake, broil orself-cleaning mode and the times set forthe timer or automatic oven operations.The display will show “PrE” whilepreheating. When the oven reachesthe selected temperature, the ovencontrol will beep and the displaywill show the oven temperature.If “F– and a number or letter” flash in the display and theoven control signals, this indicates a function error code.If your oven was set for a timed oven operation anda power outage occurred, the clock and all programmedfunctions must be reset.The time of day will flash in the display when there hasbeen a power outage. Reset the clock.If the function error code appears during the self-cleaningcycle, check the oven door latch. The latch handle may havebeen moved, even if only slightly, from the latched position.Make sure the latch is moved to the right as far as it will go.Touch the CLEAR/OFF pad. Allow the oven to cool forone hour. Put the oven back into operation. If the functionerror code repeats, disconnect the power to the range andcall for service.KITCHEN TIMER ON/OFF PadTouch this pad to select the timer feature.Then press + and – pads to adjust time.TIMER LightFlashes while in edit mode—you can changethe set time at this point. Glows when thetimer has been activated. Flashes again whenthe time has run out until the control is reset.CLOCK PadTo set the clock, touch this pad twice andthen touch the + and – pads. The time ofday will flash in the display when the ovenis first turned on.DELAY START PadUse along with the COOKING TIME orSELF CLEAN pads to set the oven to startand stop automatically at a time you set.DELAY START Time LightFlashes while in edit mode—you can changethe delay start set time at this point. Glowswhen the function has been activated.COOKING TIME PadTouch this pad and then touch the + or –pads to set the amount of time you wantyour food to cook. The oven will shut offwhen the cooking time has run out.COOKING TIME LightFlashes while in edit mode—you can changethe set time at this point. Glows when thefunction has been activated. Flashes againwhen the time has run out until the controlis reset.Throughout this manual, features and appearance may vary from your model.Using the oven controls.Safety InstructionsOperating InstructionsCare and CleaningTroubleshooting TipsConsumer Support