GE JTS10 Owner's Manual

Also see for JKS10: Installation instructions Installation instructions Brochure Installation instructions Installation instructions

Contents

GE JTS10 Owner's Manual Manual pdf 16 page image

Care and cleaning of the oven,j j SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electricalAWARNING j powerto the oven at the main fuse or circuit breaker paneI. Failure to do so may resultin electric shock or burn.[,& CAUTION I URN HAZARD: The glass cover and bulb should be removed when cool. Touching hotglass with bare hands or a damp cloth can cause burns.ReceD_a@_ .Socket_" G6.35 Bulbon some moaelsReceD_a@e Socket_G9 BulbTabOven Light ReplacementTo remove:[-_ Turn the glass cover counterclockwise 1/4turn until the tabs of the glass cover clearthe grooves of the socket.Wearing latexgloves may offer a better grip.[] Using gloves or a dry cloth, remove thebulb by pulling it straight out.To replace:[Z] use a new 120/130-volt halogen bulb, notto exceed 50 watts. Replacethe bulb withthe same type of bulb that was removed.Your model will have one of the two typesshown on the left.To determine the correctreplacement bulb, check the bulb terminals.Bulbswith 2 straight pin terminals areG6.35bulbs. Bulbswith 2 looped terminalsare G9 bulbs. (Do not interchange.) Be surethe replacement bulb is rated 120 volts or130 volts (NOT12 volts).Using gloves or a dry cloth, remove thebulb from its packaging. Do not touch thebulb with bare fingers. Oil from skin willdamage the bulb and shorten its life.@%@bk% : $/¸¸::¸¸¸¸¸¸¸¸¸¸¸¸¸%¸¸¸: iiReceptaceQrPushthe bulb straight into the receptacleall the way.Placethe tabs of the glass cover into thegrooves of the socket.Turn the glass coverclockwise 1/4 turn.For improved lighting insidethe oven,clean the glass cover frequently using awet cloth. This should be done when theoven is completely cool.Reconnect electrical power to the oven._nsome models)Oven Light Bulb tonsomemodels)m iJMax / "'_:I_engtK\ ):,Bulb, mmNOTE:Theglass cover (on some models)shouldbe removed only when cold.Wearing latex glovesmay offer a better grip.Before replacing the bulb, disconnect electricalpower to the oven at the main fuse or circuitbreaker panel. Letthe bulb cool completelybefore removing it. For your safety, do nottouch a hot bulb with a damp cloth. If you do,_i the bulb will break.Toremove:@lasscover Turn the glass cover counterclockwise 1/4turn until the tabs of the glass cover clear thegrooves of the socket. Removethe bulb.16To replace:Put in a new 40-watt appliance bulb. Placethetabs of the glass cover into the grooves of thesocket. Turn the glass cover clockwise 1/4 turn.NOTE:A 40-watt appliance bulb is smaller than astandard 40-watt household bulb.Install and tighten the cover clockwise.Reconnect electrical power to the oven.For improved lighting inside the oven, cleanthe glass cover frequently using a wetcloth. This should be done when the oven iscompletely cool.