GE JVM2052 Installation Instructions Manual

Also see for JVM2052: Owner's manual Owner's manual Owner's manual Installation instructions Installation instructions

GE JVM2052 Installation Instructions Manual Manual pdf 17 page image

17Installation InstructionsAttach the exhaust adapter to the rear of theoven by sliding it into the guides at the topcenter of the back of the oven.3ADAPT MICROWAVE OVENBLOWER FOR OUTSIDE BACKEXHAUST (cont.)B47WARNING: Risk of electric shockcan cause injury or death. Do not pull or stretchthe blower unit wiring. Make sure the wiresare not pinched.NOTE: The blower unit exhaust openings shouldmatch exhaust openings on rear of microwave oven.Push in securely until it is in the lower lockingtabs. Take care to ensure that the damper hingeis installed so that it is at the top and that thedamper swings freely.GuideGuideAdapterLocking TabsBack ofMicrowave OvenBEFORE: Fan BladeOpenings Facing Up End BEnd ACarefully pull out the blower unit. The wireswill extend far enough to allow you to adjustthe blower unit.Rotate the unit so that the exhaust ports facethe rear of the cabinet. When you insert the blowerunit, the blower wire must be as shown.Place the blower unit back into the cabinet.Check that the exhaust ports face towardthe rear of the cabinet.Exhaust portsBlower unitExhaust portsBack plateBlower unitmounting screw(2 screws)Blower platemounting screw(3 screws)Blower plateBlower unitBlower unit exhaust ports45Reattach the blower plate to the cabinet sothe exhaust ports and blower plate openingare aligned. Attach with 2 blower unit mountingscrews and then 3 blower plate mounting screws.6