GE JVM2052 Installation Instructions Manual

Also see for JVM2052: Owner's manual Owner's manual Owner's manual Installation instructions Installation instructions

GE JVM2052 Installation Instructions Manual Manual pdf 8 page image

8Installation InstructionsFind the studs, using one of the followingmethods:A. Stud finder – a magnetic device whichlocates nails.ORB. Use a hammer to tap lightly across themounting surface to find a solid sound.This will indicate a stud location.After locating the stud(s), find the center byprobing the wall with a small nail to find the edgesof the stud. Then place a mark halfway betweenthe edges. The center of any adjacent studs shouldbe 16″ or 24″ from this mark.Draw a line down the center of the studs.IMPORTANT: The microwave oven must be connectedto at least one wall stud.1Remove the installation instructions, filters, glass trayand the small hardware bag. Do not remove theStyrofoam protecting the front of the oven.Fold back all 4 carton flaps fully against carton sides.Then carefully roll the oven and carton over onto the topside. The oven should be resting in the Styrofoam.REMOVING THE MICROWAVEOVEN FROM THE CARTON/REMOVING THE MOUNTINGPLATEFINDING THE WALL STUDSB2PLACEMENT OF THE MOUNTING PLATE1WallStudsCenter3CartonPull the carton up and off the oven.Remove the 2 screws from the mounting plate. Thisplate will be used as the rear wall template and formounting. You may discard these screws.MountingPlateScrews2Styrofoam35Remove and properly discard plastic bags.41A