GE MiCOM P40 Agile Technical Manual

Also see for MiCOM P40 Agile: Technical manual Technical manual Technical manual Technical manual Technical manual

Board Part No. Compatible WithRedundant Ethernet PRP/HSR/RSTP/Failover, 2 copper ports RJ45 +Modulated/Un-Modulated IRIG-B ZN0087 002 Redundant Ethernet Configurator(S1 Agile 2.0.1 onwards)Redundant Ethernet PRP/HSR/RSTP/Failover, 1 copper port RJ45 + 1 multi-modefibre port + Modulated/Un-Modulated IRIG-B ZN0087 003 Redundant Ethernet Configurator(S1 Agile 2.0.1 onwards)2.2.1 CONFIGURING THE LAST OCTET (SHP, DHP, RSTP)If using SHP or DHP, the last octet is configured using board address switch SW2 on the board. Remove the IEDfront cover to gain access to the board address switch.Warning:Configure the hardware settings before the device is installed.1. Refer to the safety section of the IED.2. Switch off the IED. Disconnect the power and all connections.3. Before removing the front cover, take precautions to prevent electrostatic discharge damage according tothe ANSI/ESD-20.20 -2007 standard.4. Wear a 1 MΩ earth strap and connect it to the earth (ground) point on the back of the IED.E01019Chapter 4 - Configuration34 Px4x-REB-TM-EN-6