GE Monogram ZDP486ND Technical Service Manual

Also see for Monogram ZGU364ND: Owner's manual Installation instructions Installation instructions Installation instructions Installation instructions

Contents

GE Monogram ZDP486ND Technical Service Manual Manual pdf 48 page image

– 48 –Cooling FanThe cooling fan is attached on the back of the ovenwith two 1/4-in. screws. The fan vents through therear grill. On double oven models, each oven has itsown independent fan that runs only when that ovenis on. To replace the fan, it is necessary to removethe range from its installation and remove the backpanel. (See Installation, Back Panel.)In all cooking modes, the fan will not start to•operate until the oven temperature reaches200°F.It operates immediately at high speed in self-•clean as soon as the door is locked.The fan will run for a maximum of 85 minutes•after any cycle (cooking or cleaning) or until thesensor reaches 350°F, whichever comes first.In all cooking modes, the fan always runs in•low speed. It will only run in high speed in theunlikely event the oven exceeds 600°F in acooking mode.Main oven fan characteristics:High speed = 3050 RPM +/- 100•Resistance is 13• Ω measured through the blackand white wiresLow speed = 1525 RPM +/- 175•Resistance is 20• Ω through the red and whitewiresCompanion oven fan characteristics:High speed – 2700 RPM +/- 150•Resistance is 22• Ω measured through the blackand white wiresLow speed – 2225 RPM +/- 175•Resistance is 26• Ω through the red and whitewiresNote: The side panel is held to the front side of therange with 3 keyslots inside the panel that engage 3plastic pins on the range.View Inside Panel Panel Moved Out5. Move the rear of the side panel outapproximately 2 inches from the range.6. Lift the panel approximately 3/4 inch todisengage the panel from the 3 plastic pins.Keyslot (1 of 3) Plastic Pin(1 of 3)