GE Monogram ZIR36ND Dimension Manual

Monogram.™Specification Created 8/00For answers to your Monogram,®GE Profile Performance Series,™GE Profile™ or GE appliance questions, callGE Answer Center® service, 800.626.2000.RListed byUnderwritersLaboratoriesZIR36ND–GE Monogram 36" Built-In All-RefrigeratorProduct Dimensions (in inches)10-3/4" Max.10" Min.24-3/4"35" Case36" Overall84-1/2" Max.83-1/2" Min.4"73-1/2"26-3/4"Design InformationDesigned to be installed flush or semi-flush with surrounding cabinetry. Cutoutdimensions, clearances and side panel sizes are determined by the manyinstallation options available. Side panels must be used whenever the sides ofthe refrigerator will be exposed. Side panels are not required when installedinto an enclosure or between pantry and oven cabinets. IMPORTANT - Sidepanels, 1/2" minimum thickness are required when using FRAMELESSCABINETS.• Field installed custom panels, Lexan® or stainless steel panels are required.The door and grille panel sizes vary to accommodate the kit being used.• The supplied toekick is vented and must remain unobstructed for properair circulation.Optional Panel Kits:• ZWBR36: Black Lexan® Panel Kit• ZWWR36: White Lexan® Panel Kit• ZWSR36: Stainless Steel Panel KitOptional Custom Trim Kits:• ZKHR1: For installation of a custom handle of your choice onto a 1/4" Panel.• ZKTR36LH or ZKTR36RH: For installation of a 3/4" thick custom panel.• ZKHTR1: For installation of a custom handle of your choice onto a 3/4" thickpanel. (This kit must be used in combination with ZKTR36LH or ZKTR36RH).• ZKHRSS1: Tubular Stainless Steel handle for 1/4" thick panel.• ZKHTRSS1: Tubular Stainless Steel handle for 3/4" thick panel.• ZGC2: 1/4" grille panel frame side pieces for 83-1/2" and 84-1/2" installationheights. (Factory set for 84").• ZWT1: White toekick (supplied toekick is black).• ZFC1: Trim strip for side-by-side installation oftwo products.Additional Specifications• A 115 volt 60Hz., 15 or 20 amp power supply is required. An individualproperly grounded branch circuit or circuit breaker is recommended. Install aproperly grounded 3-prong electrical receptacle recessed into the back wall.Electrical must be located on rear wall as shown.• Water line can enter opening through the floor or back wall. The water lineshould be 1/4" O.D. copper tubing between the cold water line and waterconnection location, long enough to extend to the front of the refrigerator.Installation of an easily accessible shut off valve is recommended.Clearances:• If the refrigerator or freezer is installed in a corner:A 4" clearance is required on the hinge side for a 90° door opening andaccess to fresh food drawers. A 10" clearance is required on the hinge side toremove pans.7 1/2"74" From Floorto Bottomof Electrical84 1/2" max83 1/2" minFinishedOpening*Finished WidthElectricalArea5"5"5"3 1/2"24 3/4" TotalDepthWater Supply 3 1/2"Wall View7"* 36" Min. for a flush installation into an enclosure.* 35-1/2" Min. for a semi-flush installation into an enclosure.Note: Additional cutout width may be required when side panelsare used. Add side panel thickness to the finished cutout width tocalculate rough-in width.