GE Monogram ZV1050 Installation Instructions Manual

Also see for Monogram ZV1050: Use and care guide Installation instructions Owner's manual Owner's manual Owner's manual

Contents

11Installation InstructionsSTEP 8 INSTALL DECORATIVE DUCT COVERS• Pretap or drive decorative screw into the screw holeson the support frame. This will make screw installa-tion easier.• Separate the two decorative duct covers.• Select the inside cover (top), which has two screwholes in the top.• Slide the decorative duct cover over the supportframe and push to the ceiling.• Attach to the hood support at the top with 2 supplieddecorative screws.• Locate the 3rd decorative screw in the hardwarepackage. Set aside.• Slide the lower decorative duct over the installedupper duct and push to the top, keeping the bottomslotted hole to the left.• Install the decorative stop screw in center hole ofupper (inner) duct cover. The decorative screw will actas a stop screw and prevent the lower decorative ductcover from sliding down.CAUTION: The stop screw must be installed.Failure to do so could result in personal injury ordamage to the duct cover.PRUDENCE – La vis supérieure doit être enplace, afin d’éviter les blessures ou d’endommager lecapot antipoussière.STEP 9 INSTALL HOODNote: AT LEAST THREE PEOPLE ARE REQUIREDTO COMPLETE THIS INSTALLATION!• Lift the hood up to the support frame. Carefullyalign the hood mounting holes to support frameholes, and at the same time, the hood duct connectorinto the duct.• Install screws through the hood and hood support.• Check hood level in both directions.• Check to be sure that the duct is positioned over thehood connector.• Seal the duct connection with duct tape.Note: Do not drive screws through this duct connec-tion. Doing so will prevent proper damper operation.Stop ScrewApply Duct Tapeto Seal DuctConnectionInstall4 Lock Washersand 4 Machine BoltsBottomDuctCoverPretap2 ScrewHoles(OneOnEachSide)Top DuctCoverInstall Screw onEach SideBottom Duct CoverTop DuctCoverBottom DuctCoverTop DuctCoverInstall StopScrew in Holeof Upper (Inner)Duct CoverStopScrew