GE Monogram ZVC30LSS Installation Instructions Manual

Also see for 36" CUSTOM HOOD INSERT ZVC36LSS: Dimensions and installation information Owner's manual Installation instructions Installation instructions

Contents

6Design InformationPRODUCT DIMENSIONS4″34-1/2″21-1/4″27-1/2″14″16-3/4″25-3/4″13″14″1/2″4-1/4″7-1/2″ The bottom edge of the insert sleeve has a 7/8″wide flange on the sides and a 1/2″ wide flangeon the front and back.Remote Location for the ControlThe control may be removed from the hoodand installed into a wall or countertop. A 30-ft.length of wire is supplied to accommodate mostinstallations. A blanking plate covers the openingwhen the controls are removed.The overall size of the control is 4-1/4″ wide and2-1/4″ deep.We recommend that the cutout in granite or otherhard surfaces be made before the countertop isinstalled.7/8″1/2″1/2″The stainless steel liner is shipped with each hoodinsert. This non-combustible liner protects theunderside of the canopy.Custom LinerIf you are not using the supplied liner, you mayconstruct a custom non-combustible liner. Use thesupplied liner as a template. The opening must be26″W x 13-3/16″D. 3/4″ thick material mustsurround the opening to allow the sleeve lockingclips to engage. The insert sleeve inside the cabinetshould be positioned 1/2″ from the rear wall sothat the center of the 8″ duct is 5-1/2″ from therear wall.*OpeningZVC36The custom canopy must be sized to fit the insertsleeve. Construct the canopy with an openingthat is:26″W x 13-3/16″DThe opening must be constructed of 3/4″ thickmaterial to allow the sleeve locking clips toengage.The Supplied LinerDimensions and Specifications (in inches)Outside DimensionsThe Insert Sleeve13″1-11/16″3-11/16″Control cutout