GE NX-1308E - Caddx 8 Zone LED Keypad Installation And Startup Manual

NX-8 Control4GENERAL DESCRIPTIONThe NetworX NX-8 represents a new approach to security systems design. Drawing on our experience in the worldmarket as the largest exporter of USA manufactured controls, we have developed the most flexible, durable, and user-friendly control ever seen in our industry. Featuring sophisticated software that allows up to 99 users to interface with48 zones, 8 partitions, and a host of integrated fire, access, verification, and input/output modules, all reported with themost comprehensive and fast SIA and Contact ID formats. The NetworX design allows a fully loaded system to behoused in one single metal enclosure, establishing for the first time, a logical solution and design response to modularsystems. Up to 32 modules can be added to expand the capabilities of the NX-8.Board InstallationInside the can, several 2-holed insertion points have been constructed. Thisallows for either vertical or horizontal placement of the modules. Notice thateach insertion point has two sizes of holes -a larger hole and a smaller hole.Diagram 1: The black plastic PCB guides are grooved on one edge where thePC board will be seated. The end with the half-moon protrusion fits into thelarger hole. The smaller hole is for the screw.Diagram 2: Place the first black plastic PCB guide in the top insertion point,grooved edge downward. The half-moon protrusion will be in the large hole. Itdoes not require force. Insert one of the provided screw into the smaller hole(from inside the can) to secure it in place. A screwdriver should reach throughthe notch that runs the length of the guide to tighten the screw. The secondPBC guide should be positioned opposite the first (grooved edge up) andplaced in the lower insertion point, using the same procedures describedabove. Once mounted, screw it in securely.Diagram 3: The PC Board should slide freely in the grooves of both guides.K IMPORTANT!1. If separate power supplies are necessary to accommodate additional devices, safetystandards require that each power supply be prominently marked with adequate instructionsfor removing all power from the unit.2. Dispose of used batteries according to the manufacturer’s instructions and/or localgovernment authorities.3. Installation personnel should thoroughly read and understand the installation instructionsand the users manuals for the panel and all the accessories to be included with the systembefore attempting to install a security system. WARNING!Replace only with Panasonic #LC12V4BP or Yuasa #NP4-12 battery. Observe polarity wheninstalling a new battery. Installing the battery backwards may cause damage to the panel. Thereis a risk of explosion if the battery is replaced with an incorrect type.NOTEElectrical codes will vary depending upon the country and city where the system is installed. It isthe installer’s responsibility to ensure that the electrical installation is safe and conforms to allapplicable codes, laws, or regulations. Only qualified persons should connect this device to themains supply.