GE PACSystems RX3i Application Manual

Also see for PACSystems* RX3i: Reference manual User manual CPU Programmer's Reference Manual Quick start guide Quick start guide

Chapter 3. Application System ArchitectureGFK-2928 December 2017 9Figure 4: Fault Table DisplayThe message provides the slot number (S08 in the example) in which the PROFINET Controller is installed, thedevice number (D004) for the Bus A GCG, the serial bus address (SBA02) for the Genius device, and either Lossof Device (LOD) or Addition of device (AOD).3.4 Development EnvironmentThe software components require Proficy Machine Edition, version 9.5 or later.3.5 Simplified Description of Project Upgrade Steps• Convert the existing Series 90 project into an RX3i project.• Import Software Components for Dual Bus into the Proficy Machine Edition Toolchest.• Edit the Primary/Secondary Hardware Configurations.• Drag the Dual Bus application components from the Toolchest into the project’s PLC Program Blocks.• Add/Edit the Dual Bus Application Blocks:o Add an instance of the ladder block BUSSES in _Main.o Enter GBusses for the name.o Edit INIT_GB00 in BUSSES to match the configuration of the Genius devices on the first dualbus pair.o If there are more dual busses then:▪ Copy, then paste the block named INIT_GBnn in BUSSES.▪ Rename INIT_GBnn by changing nn to the next bus number.▪ Edit the block contents to accommodate the configuration settings for the PNC,GCG, and Genius device reference addresses.▪ Add a new instance of the function block DBUS.▪ Name the instance using DBnn by changing nn to the next bus number.▪ Repeat for the remaining busses, if any.