GE PDCF1NBW Owner's Manual And Installation Instructions

Also see for 21: Owner's manual Use and care & installation guide Use and care & installation guide Owner's manual Use and care & installation guide

Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Installation InstructionsAbout the automatic icemaker. ge.comAutomatic Icemaker (on some models)The icemaker will produce seven cubesper cycle—approximately 100–130 cubesin a 24-hour period, depending on freezercompartment temperature, roomtemperature, number of door openingsand other use conditions.See below for how to access ice and reachthe power switch.If the refrigerator is operated before thewater connection is made to the icemaker,set the power switch in the O (off) position.When the refrigerator has been connectedto the water supply, set the power switch tothe l (on) position. The icemaker powerlight will turn green when the freezer lightswitch is pressed in or when the freezerdoor is closed.The icemaker will fill with water when itcools to 15°F (–10°C). A newly installedrefrigerator may take 12 to 24 hours tobegin making ice cubes.You will hear a buzzing sound each timethe icemaker fills with water.Throw away the first few batches of ice toallow the water line to clear.Be sure nothing interferes with the sweepof the feeler arm.When the bin fills to the level of the feelerarm, the icemaker will stop producingice. It is normal for several cubes to bejoined together.If ice is not used frequently, old ice cubeswill become cloudy, taste stale and shrink.NOTE: In homes with lower-than-average waterpressure, you may hear the icemaker cycle multipletimes when making one batch of ice.NOTE: Set the power switch to the O (off) positionif the water supply is shut off.A newly installed refrigerator may take 12 to 24 hours to begin making ice.IcemakerFeeler ArmPowerSwitchGreenPower LightAccessing Ice and Reachingthe Power SwitchTo reach the icemaker power switch, pull theshelf above the ice bin straight out. Alwaysbe sure to replace the shelf.To access ice, simply pull the bin forward.To access ice.ShelfIce BinTo reach the power switch.ShelfIce BinIcemaker Accessory KitIf your refrigerator did not come alreadyequipped with an automatic icemaker,an icemaker accessory kit is available atextra cost.Check the back of the refrigerator forthe specific icemaker kit needed foryour model.To Use the DispenserPress the glass gently against the top of thedispenser cradle.The spill shelf is not self-draining. Toreduce water spotting, the shelf should becleaned regularly.If no water is dispensed when the refrigerator is firstinstalled, there may be air in the water line system.Press the dispenser arm for at least two minutes toremove trapped air from the water line and to fill thewater system. To flush out impurities in the waterline, throw away the first six glassfuls of water.Locking the DispenserPress the LOCK pad for 3 seconds to lockthe dispenser and control panel. To unlock,press and hold the pad again for 3 seconds.Door AlarmTo set the alarm, press the DOOR ALARMpad. The indicator light will illuminate.This alarm will sound if either door isopen for more than 2 minutes. Thebeeping stops when you close the door.Spill Shelf 11Dispenser Cradle