GE PGS908 Installation Instructions Manual

Also see for Profile PGS908: Installation instructions Brochure Technical service guide Use and care manual Owner's manual

GE PGS908 Installation Instructions Manual Manual pdf 1 page image

JIlnstallation J Gas Slide-In RangeJnstructions PGS908, PGS975I_ Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com IIIn Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca IIN THE COMMONWEALTH OFMASSACHUSETTS:• This product must be installed by alicensed plumber or gas fitter.• When using ball-type gas shut-off valves,they shall be the T-handle type.• A flexible gas connector, when used, mustnot exceed 3 feet.BEFORE YOU BEGINRead these instructions completelyand carefully.• IMPORTANT - Savetheseinstructions for local inspector's use.• IMPORTANT - Observeallgoverning codes and ordinances.• Note to Installer - Be sure to leave theseinstructions with the Consumer.• Note to Consumer - Keep theseinstructions for future reference.• Product failure due to improper installationis not covered under the Warranty.-_WARNING - This appliance mustbe properly grounded.• IMPORTANT - Leak testing of theappliance shall be conducted according tothe manufacturer's instructions.• Proper installation is the responsibilityof the installer and product failure due toimproper installation is NOT covered underwarranty.31-10642-1 03-07 JRPARTS INCLUDEDRear Filler2 ScrewsScrews Anti-Tip BracketMATERIALS YOU MAY NEEDJoint Sealant Shut Off ValvePipe FittingsCSA-Approved Flexible Gas Line3/8" Min. ID, 1/2" NPT Connection,3-foot Maximum Length (Massachusetts Only)TOOLS YOU WiLL NEED1/4" Nut Driver LevelPhillips HeadScrewdriverPipe WrenchFlat-bladeScrewdriver Wrench or Pliers(for 1-7/16" Nut)Tape Measure DrillSafety Glasses