To Set the ClockThe clock must be set to the correct timeof day for the automatic oven timingfunctions to work properly. The time ofday cannot be changed during a timedbaking or self-cleaning cycle.Touch the CLOCK pad.Touch the number pads.Touch the START pad.Make sure the clock is set to thecorrect time of day.To Set the TimerTouch the KITCHEN TIMERON/OFF pad.Touch the number pads until theamount of time you want showsin the display. For example, to set2 hours and 45 minutes, touch 2, 4and 5 in that order. If you make amistake touch the KITCHEN TIMERON/OFF pad and begin again.Touch the START pad.After touching the START pad, SET disappears;this tells you the time is counting down, althoughthe display does not change until one minute haspassed. Seconds will not be shown in the displayuntil the last minute is counting down.When the timer reaches :00, thecontrol will beep 3 times followedby one beep every 6 seconds untilthe KITCHEN TIMER ON/OFF padis touched.The 6-second tone can be canceled by followingthe steps in the Special features of your ovencontrol section under Tones at the End of aTimed Cycle.The timer is a minute timer only.The timer does not control ovenoperations. The maximum setting onthe timer is 9 hours and 59 minutes.To Reset the TimerIf the display is still showing the timeremaining, you may change it bytouching the KITCHEN TIMER ON/OFF pad,then touch the number pads until thetime you want appears in the display.If the remaining time is not in the display(clock, delay start or cooking time are inthe display), recall the remaining time bytouching the KITCHEN TIMER ON/OFF padand then touching the number pads toenter the new time you want.To Cancel the TimerTouch the KITCHEN TIMER ON/OFFpad twice.Using the clock and timer.16Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions