GE PGS908 Technical Service Manual

Also see for Profile PGS968: Installation instructions Owner's manual Installation instructions Owner's manual Owner's manual

Contents

GE PGS908 Technical Service Manual Manual pdf 32 page image

– 32 –When installing the door gasket, it is helpful to foldthe gasket in half and locate the center clip. Insertthe clip at the top of the door and work your wayaround the door.Make sure the gasket is cross tucked in thebottom slots of the inner door panel. Use a smallscrewdriver to tuck the loose ends of the gasket intothe slots. The overlap is required to ensure a properdoor seal.Cross TuckStorage Drawer RemovalTo remove and replace the storage drawer:Pull the drawer out until it stops. Lift the front of thedrawer until the stops clear the guides. Pull forwardand remove the drawer.To replace the storage drawer, place the drawer railin the guides and push the drawer in until it stops.Lift the front of the drawer and push in until thestops clear the guides. Lower the front of the drawerand push in until it closes.RailGuideStopStopRange RemovalWARNING: Shut off gas to the range before rangeremoval.Caution: Take the necessary precautions to protectthe floor from damage caused by moving the range.To remove the range:Note: It may be helpful to remove the door tolighten the range for removal. (See Oven DoorRemoval.)Remove the storage drawer.1.Carefully pull the range out until the rear2.leveling leg has cleared the anti-tip bracket.Unplug the range.3.Disconnect the gas supply connector.4.Using an adjustable wrench, screw the back5.leveling legs out to raise the rear of the rangeabove the counter.Lift the front of the range up while carefully6.pulling the range from the installation.Continue to pull the range out while lifting up7.until the back of the range is accessible.Note: Make sure the anti-tip bracket is installedcorrectly before pushing the range back into place.