Using the clock, timer and control lockout.To Set the ClockThe clock must be set to the correct time of dayfor the automatic oven timing functions to workproperly. The time of day cannot be changedduring a timed baking or self-cleaning cycle.Press the Clock pad.Press the number pads.Press the Start pad.Make sure the clock is setto the correct time of day.To Set the TimerPress the Kitchen Timer On/Off pad.Press the number pads until the amountof time you want shows in the display. Forexample, to set 2 hours and 45 minutes,press 2, 4 and 5 in that order. If you makea mistake, press the Kitchen Timer On/Offpad and begin again.Press the Start pad.After pressing the Start pad, SET disappears;this tells you the time is counting down,although the display does not change until oneminute has passed. Seconds will not be shownin the display until the last minute is countingdown.When the timer reaches :00, the controlwill beep 3 times followed by one beepevery 6 seconds until the Kitchen TimerOn/Off pad is pressed.The 6-second tone can be canceled byfollowing the steps in the Special features ofyour oven control section under Tones at theEnd of a Timed Cycle.The timer is a minute timer only.The timer does not control ovenoperations. The maximum settingon the timer is 9 hours and 59minutes.To Reset the TimerIf the display is still showing the time remaining,you may change it by pressing the KitchenTimer On/Off pad, then press the number padsuntil the time youwant appears in the display.If the remaining time is not in the display (clock,delay start or cooking time are in the display),recall the remaining time by pressing theKitchen Timer On/Off pad and then pressingthe number pads to enter the new time youwant.To Cancel the TimerPress Kitchen Timer On/Off pad twice.Your control will allow you to lock out the touchpads so they cannot be activated when pressed.NOTE: On double oven models, this activatesthis feature for both ovens.To lock/unlock the controls:Press the 9 and 0 pads at the same timefor 3 seconds, until the display shows LOCON.To unlock the control, press the 9 and 0pads at the same time for 3 seconds, untilthe display shows LOC OFF.When this feature is on and the touch pads arepressed, the control will beep and the displaywill show LOC ON.NOTES:■ The control lockout mode affects all touchpads. No touch pads will work when thisfeature is activated.■ The adjustment will be retained in memoryafter a power failure.Control Lockout9