GE PP950 Owner's Manual

Also see for PP950BMBB - 30" Smoothtop Electric Cooktop: Installation instructions Dimensions and installation information

Contents

GE PP950 Owner's Manual Manual pdf 9 page image

This feature is only used on the dualsurface element when the pan detectionfeature is enabled. When a small pan isplaced on the surface element, the smallsurface element will activate. When a panlarger than 6.0 inches is placed on thesurface element, the large surfaceelement will automatically activate. Thisfeature may be overridden for a singlecooking session while leaving the pandetection feature active (see Dual SurfaceElement section).To turn off this feature and the pan detectionfeature:Touch the PAN pad.The light next to the pad will go out,indicating that pan features are turned off.NOTE: The pan must be centered over thesurface element for this feature to work properly.This feature automatically turns off asurface element after 60 seconds if a panis absent from the surface element. Thepower level display will flash until thesurface element automatically turns offwhen the control detects the absenceof a pan.To activate and deactivate pan detection forall surface elements:Touch the PAN pad. (At least one surfaceelement must be on.) The display willflash “PAN ON” when the pan detectionfeature is on.A signal will sound and a light next tothe PAN pad will indicate whether thefeature is active. If the light is on, pandetection is on, and if the light is off,pan detection is off. When the pandetection feature is disabled, the pansizing feature is also disabled.NOTES: For this feature to work properly, thepan diameter must be greater than 4.0inches and centered on the surfaceelement. This feature may not operate properlywith rounded, curved or warped panbottoms (see the Types of Cookwaresection). This feature will not work withglass-ceramic/stoneware cookware(see the Types of Cookware section).9Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportHow to Lock the CooktopIMPORTANT: As a convenience, youcan lock the entire cooktop at any timewhen it is not in use or before cleaning.Locking the cooktop will prevent surfaceelements from being turned onaccidentally.To lock the cooktop:Touch and hold the CONTROL LOCK padfor 3 seconds.A two-beep signal will sound, the word“LOCK” will appear in the TIMER display,and the Control Lock light will turn on,indicating that the cooktop is locked.If the cooktop is locked while the surfaceelements or timer are in use, they willautomatically turn off.To unlock:Touch and hold the CONTROL LOCK padagain for 3 seconds.A two-beep signal will sound, and theControl Lock light will go out, indicatingthat the cooktop is unlocked.CONTROLLOCKCONTROLLOCKHow to Operate the Kitchen TimerNOTE: The kitchen timer will NOT turn off thesurface elements when the time reaches 00:00.To operate the kitchen timer, use thepads below the TIMER display.Touch the ON/OFF pad and thentouch the (+)/(-) pad to choose thedesired time setting. If the (+)/(-) pad isheld for several seconds, the timer willincrease or decrease at a faster rate.After you have chosen your desired time,the timer will automatically start to countdown from the hours/minutes that youhave selected. After the timer countsdown to the last minute, it will countdown in seconds until 00:00. After thetime has run out, the control will beeptwice every five seconds until the timer isturned off. Touch the ON/OFF pad to turnthe timer off.ONOFFORTIMERUsing the Pan Detection FeaturePANUsing Pan SizingPANge.com