Dimensions and Installation InformationFor answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center ® service,800.626.2000.Listed byUnderwritersLaboratoriesPGP989SNGE Profile™ 30" Downdraft Gas Cooktop227 ⁄16ʺ(229⁄16ʺ SS)201⁄ 2ʺ22ʺ297⁄8ʺ(30ʺ SS)23 ⁄ 16ʺ(21⁄ 4ʺ SS)283 ⁄4ʺ251-7/8"MIN. Required*20-5/8Cut-out Dimensions (in inches)28-7/8*U.L. Requirement.Note: A 5" minimum spacing to adjacent side wall is requiredSpecification Revised 4/09230285*Note: A 5" minimum spacing to adjacent side wall is requiredDimension and installation information are shown in inches.Wall Installation: Wall installations require 25”countertop depth. When cabinet is flush againstthe wall, the fan housing can be rotated to thehorizontal position for direct venting throughrear wall. Make a countertop cutout in therange cabinet according to unit dimensionsand installation type. Duct hole is positioned inback of cabinet for through-the-wall ducting.Requires special offset adapter JXRW89.Peninsula or Island Installation: For peninsula/islands a minimum 26” countertop depth is suggested.Blower should be in vertical position. Island orpeninsula cabinets may require adjustment in cutoutdepth and/or location within the width dimensions.Duct hole is positioned in bottom of cabinet for islandor peninsula installation.Slab Installation: For peninsula or island installationand rear wall ducting, 6” PVC duct or locallyapproved piping should be used if installing undera poured concrete slab.Installation Information: Before installing, consultinstallation instructions, packed with product, forcurrent dimensional data.Note: These cooktops are approved for indoor use only.209410-1/216CLCabinet Dimensions (in inches)227⁄16ʺ(229⁄16ʺ SS)201⁄ 2ʺ22ʺ297 ⁄8ʺ(30ʺ SS)23 ⁄ 16ʺ(21⁄ 4ʺ SS)283 ⁄4ʺ251-7/8"MIN. Required*20-5/8Cut-out Dimensions (in inches)28-7/8*U.L. Requirement.Note: A 5" minimum spacing to adjacent side wall is required