GE PSB9240DFBB Installation Instructions Manual

Also see for Advantium PSB9240DF: Dimension Guide Installation instructions Installation instructions

Contents

8Installation PreparationPreparation WITH an Accessory Storage DrawerNOTE: MODEL ZSC2202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATIONWITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.Installation over a GE/MonogramWarming Drawer:*For existing cutouts, a maximum width of 28-1/2”is acceptable. If the opening is slightly wider,secure a furring strip on each side of the cutoutfor securing the oven.NOTE: Additional clearances between the cutoutsmay be required. Check to be sure the ovensupports above the Warming Drawer location do notobstruct the required interior depth and height. SeeWarming Drawer installation instructions for details.30” 23-1/2”25-1/4”Min.*21”36-3/4”Min.2” Min.(3” recommended)Per warmingdrawerrequirementConstructSolid BottomMin. 3/8”PlywoodSupportedby 2x4 or 2x2Runners allFour SidesPREPARE THE OPENINGThe Advantium 240V can be installed incombination with other GE/Monogram appliances.Always follow each product’s InstallationInstructions to complete the installation.Single Advantium 240V Installation:Order a 30” wide single oven cabinet or cut theopening in a wall to the dimensions shown.* For existing cutouts, a maximum width of 28-1/2”is acceptable. If the opening is slightly wider,secure a furring strip on each side of the cutoutfor securing the oven.$OZD\VPDLQWDLQμPLQLPXPKHLJKWIURPthe floor to the cutout in any single or combinedinstallation.Allow 3/4” to 2-1/8” case trim overlap on the sidesand 7/8” overlap on the bottom of the openingfor all models. The amount of overlap on the sidesdepends on the actual cutout width. Allow 1-1/4”case trim overlap on the top for model PSB9120and 3/4” overlap on the top for models ZSC2200,ZSC2200, ZSC2201 and ZSC2202.2YHQRYHUODSVZLOOFRQFHDOFXWHGJHVRQDOOVLGHVof the opening.30” 23-1/2”25-1/4”Min.*21”ConstructBaseMin. 3/8”PlywoodSupportedby 2x4 or2x2 Runnersall FourSides36-3/4”Min.PREPARE THE OPENING (CONT.)Single Advantium 240V Installation (cont.)When installed over a single oven or a warmingdrawer, allow at least 2” between the two openings.This separation will provide clearance for bottomoverlap of the Advantium 240V and the otherappliance overlaps.Construct a solid oven floor of 3/8” min. thick plywoodsupported by 2 x 4 or 2 x 2 runners on all sides.7KHVXSSRUWPXVWEHOHYHODQGULJLGO\PRXQWHGflush with the bottom edge of the cutout.