BEFORE YOU BEGINRead these instructions completelyand carefully.• IMPORTANT — Save theseinstructions for local inspector’s use.• IMPORTANT — Observe allgoverning codes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep theseinstructions for future reference.• Skill level – Installation of this appliancerequires basic mechanical skills.• Completion time – Refrigerator Installation30 minutesWater Line Installation30 minutes• Proper installation is the responsibility ofthe installer.• Product failure due to improper installationis not covered under the Warranty.If the refrigerator has already been installed,remove the base grille (see Step 2 in Movingthe Refrigerator), then skip to Step 5 inInstalling the Refrigerator.Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.comIn Canada, call 1.800.361.3400 or Visit our Website at: geappliances.caInstallation RefrigeratorInstructions Models 23, 25, 26, 27 & 29If the refrigerator has an icemaker, it will haveto be connected to a cold water line. A GEwater supply kit (containing tubing, shutoffvalve, fittings and instructions) is available atextra cost from your dealer, by visiting ourWebsite at ge.com (in Canada atgeappliances.ca) or from Parts andAccessories, 800.626.2002 (in Canada1.888.261.3055).PREPARATIONWATER SUPPLY TO THE ICEMAKERTOOLS YOU WILL NEED23Phillips Head Screwdriver3/8″ and 5/16″ Socket 1/2″ and 7/16″ WrenchPlastic Putty Knife1/8″ Hex Wrench