GE Profile 405 Owner's Manual

Also see for Profile 405: Owner's manual Owner's manual Owner's manual

Contents

About reversing the door.9Reversing the DoorTools needed:nStandard #2 nTape-tipped nNeedle-nosedPhillips screwdriver putty knife pliersOpen the door and remove the filler plugs opposite the hinges. With the doorcompletely open, remove the bottom screw from each hinge on the dryer face. Insertthese screws about half way into theTOP holes, for each hinge, on the opposite side(where you removed the filler plugs). Apply firm pressure to get the screw started inuntapped holes.Loosen top screw from each hinge on the dryer face half way. With one hand holdingthe top of the door and the other hand holding the bottom, remove the door from thedryer by lifting itUP andOUT.Rotate the door 180°. Insert it on the opposite side of the opening by moving the doorIN andDOWN until the top hinge and the bottom hinge are resting on the top screwsinserted in step 1.Remove the remaining screws from the side of the opening from which the door wasremoved. With these screws secure each hinge at the bottom. Tighten the two topscrews of each hinge. Reinsert the plastic plugs on the side from which the door wasremoved.4321Customer ServiceTroubleshooting TipsOperating InstructionsSafety InstructionsDrying Rack–on some modelsA handy drying rack may be used for dryingarticles such as stuffed toys, pillows orwashable sweaters.Hook the rack over the lint filter so the rackextends into the dryer drum.NOTE:n The drying rack must be used with theTIMED CYCLE.n Do not use this drying rack when there areother clothes in the dryer.