GE Profile P2S975DEP Installation Instructions Manual

Also see for Profile P2S975: Brochure Installation instructions Owner's manual Owner's manual Installation instructions

Contents

TOOLS YOU WILL NEED• 1/4” Nut Driver • Level • Pipe Wrench• Tape Measure • Drill • Safety Glasses• Phillips Head • Flat Head • Wrench or PliersScrewdriver Screwdriver (for 1 7/16” Nut)1MATERIALS YOU MAY NEED31-10641-3 03-09 JRPrinted in the United StatesQuestions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.comIn Canada, call 1.800.561.3344 or Visit our Website at: www.GEAppliances.caInstallation Self-Cleaning Dual FuelInstructions Slide-In Range P2S975BEFORE YOU BEGINRead these instructions completelyand carefully.• IMPORTANT — Save theseinstructions for local inspector’s use.• IMPORTANT — Observe allgoverning codes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep theseinstructions for future reference.• Product failure due to improper installationis not covered under the Warranty.WARNING — This appliance mustbe properly grounded.• Proper installation is the responsibilityof the installer and product failure dueto improper installation is NOT coveredunder warranty.WARNING — Before beginningthe installation, switch power off at servicepanel and lock the service disconnecting meansto prevent power from being switched onaccidentally. When the service disconnectingmeans cannot be locked, securely fastena prominent warning device, such as a tag,to the service panel.IN THE COMMONWEALTH OFMASSACHUSETTS:• This product must be installed bya licensed plumber or gas fitter.• When using ball-type gas shut-off valves,they shall be the T-handle type.• A flexible gas connector, when used,must not exceed 3 feet.PARTS INCLUDEDAnchor SleevesLag Bolts(For Concrete Floors Only)Shut Off ValvePipe FittingsCSA-Approved Flexible Gas Line3/8″ Min. ID, 1/2″ NPT Connection,3-foot Maximum Length (Massachusetts only)Joint SealantScrewsRear Filler2 ScrewsFOR YOUR SAFETYIf you did not receive an anti-tip bracket with yourpurchase, call 1.800.626.8774 to receive one at no cost.(In Canada, call 1.800.561.3344.)For installation instructions of the bracket, visit:GEAppliances.com. (In Canada, www.GEAppliances.ca.)Anti-Tip BracketKit Included