GE Profile PFSF6PKX Owner's Manual & Installation Instructions

Also see for Adora 29: Owner's manual and installation instructions

Installation InstructionsINSTALLING THE REFRIGERATORREFRIGERATOR LOCATION• Do not install the refrigerator where the temperature willgo below 60°F (16°C) because it will not run often enoughto maintain proper temperatures.• Do not install the refrigerator where the temperature willgo above 100°F (37°C) because it will not perform properly.• Install it on a floor strong enough to support it fully loaded.CLEARANCESAllow the following clearances for ease of installation, properair circulation and plumbing and electrical connections.Sides 1/8” (3 mm)Top 1” (25 mm)Back 1” (25 mm)REMOVING THE REFRIGERATOR DOORS• IMPORTANT NOTE: This refrigerator is 355/8” deep.Doors and passageways leading to the installationlocation must be at least 36” wide in order to leavethe doors and handles attached to the refrigeratorwhile transporting it into the installation location.If passageways are less than 36”, the refrigeratordoors and handles can easily be scratched and damaged.The top cap and doors can be removed to allow therefrigerator to be safely moved indoors. If passagewaysare less then 31”, the leveling legs must be removed aswell. Start with Step 1.• If it is not necessary to remove doors, skip to Step 11.Leave tape and all packaging on doors until therefrigerator is in the final location.• NOTE: Use a padded hand truck to move this refrigerator.Place the refrigerator on the hand truck with a sideagainst the truck. We strongly recommend thatTWO PEOPLE move and complete this installation.REMOVE THE FRESH FOODDOOR HANDLEHandle Design varies based on models, howeverInstallation is same.Stainless steel:REMOVINGTHE DOORHANDLE: Loosenthe set screws withthe 3/32” Allenwrenchand removethe handle.Plastic handle:REMOVINGTHE DOOR HANDLE:Slide the handle upand off of themounting fasteners.NOTE: If the handle mounting fasteners need to betightened or removed, use a Phillips-head screwdriver.AA1MountingFastenersMountingFastenersBadgeBadgeREMOVE THE FREEZER DOOR HANDLEHandle Design varies based on models, howeverInstallation is same.Stainless steel and plastic handles:Loosen the set screws located on the undersideof the handle with the 1/8” Allen wrench and removethe handle.NOTE: If the handle mounting fasteners need to betightened or removed, use a Phillips-head screwdriver.A2AAA26