GE Profile PHB925SB1SS Technical Service Manual

Contents

– 37 –Note: When reinstalling the sensor, use a small flat-blade screwdriver to push and guide the sensor wireharness into the oven liner.Broil ElementThe broil element will not work if the•temperature probe is plugged in.• The broil element is located on the back wall ofthe oven. The oven sensor must be removed toaccess the broil element.The broil element is rated at 3800 watts and hasan approximate resistance value of 15 Ω. Whenenergized, the broil element will draw approximately15 amps.To remove the broil element:Remove the 1/4-in. hex-head screw that1.attaches the sensor to the back of the ovencavity. (See Oven Temperature Sensor.)Remove the four 1/4-in. hex-head screws that2.hold the broiler to the oven cavity.Broil Element3. Carefully pull, then lower the broiler elementtowards the front of the oven.4. Disconnect the wires from the broiler element.Disconnect DisconnectNote: Upon reassembly, ensure displaced insulationaround oven and components is returned to itsoriginal position.Note: Upon reassembly, ensure displaced insulationaround oven and components is returned to itsoriginal position.