GE Profile PHP900 Technical Service Manual

Also see for Monogram ZHU30: Owner's manual Installation instructions Installation instructions Owner's manual Installation instructions

– 13 –Boost is the highest power level, designedfor large quantity rapid cooking andboiling. Boost will operate for a maximumof 10 minutes. After 10 minutes, it willautomatically revert to power level 9.Boost may be repeated after the initial10 minute cycle.CAUTION: Do not leave a pot unattendedwhile in the Boost Mode.To start the Boost power setting:Place a pan matching the size of theinduction element over the selectedindicator ring.Touch the ON/OFF pad. “5” will flashin the display.Touch and hold the (+) pad until thedisplay reads “H.”NOTE: If the pan is removed, the displaywill flash “F” alternating to “H”. After 30seconds, the elements will turn offautomatically.Sounds you may hear:You may hear a slight “buzz” sound whencooking with the Boost or high mode. Thisis normal. The sound depends on the typeof pot being used. Some pots will “buzz”louder depending on the material. A “buzz”sound may be heard if the pan contentsare cold. As the pan heats, the sound willdecrease. If the power level is reduced, thesound level will go down.Boost Setting11Power SharingFour burner cooktops are divided into two separateheating zones. The right and left side cooking zonesare powered by separate and independent inductiongenerators. One generator controls 2 elements, or twocooking zones within a heating section share the powerof one generator.Five burner cooktops are divided into 3 zones. Theright and left side have separate cooking zones and thelarge center element is another separate cooking zone.Power Sharing is activated when both elements in thesame cooking zone are activated and one element isset for Boost (H). The element that is not set for Boostwill change to a lower power level. This is calledPower Sharing. When Boost operation is complete(10 minutes), the other element may be reset to anypower level. Both elements can operate simultaneouslyat normal power level settings of “L” to 9.4 burner cooktops with right and left side (2) induction generators.5 burner cooktops with right, left and center (3) induction generators.“H” indicates that the Boost powerlevel has been selected for rapidcooking and boiling.IMPORTANT NOTE FOR FOUR BURNER MODELS:The elements on the right side share one generator.Both elements can operate at any non-Boost (level Lto 9) power level at the same time. If the large frontelement is set for "H" or Boost, the smaller elementat the right rear will be deactivated or turned offautomatically. The smaller right rear element can beactivated and set for any power level after the Boostoperation of the larger element is completed (10minutes).(Continued next page)