For answers to your Monogram® or GE®appliance questions, visit our website atgeappliances.com or call GE Answer Center®service, 800.626.2000.PHS920SFGE Profile™ Series 30" Slide-In Induction and Convection Range with Warming DrawerSpecification Created 6/13 220457Listed byUnderwritersLaboratoriesDimensions and Installation Information (in inches)All GE ranges are equipped withan Anti-Tip device. The installationof this device is an important,required step in the installationof the range.*ADA qualified basedon Uniform FederalAccessibility Standards*Receptacle Locations: Locally approved flexible service cord or conduit must be used becauseterminals are not accessible after range installation. See shaded area in drawing for location ofelectrical outlet box. Recommended outlet locations allow range to be installed directly against rearwall.Note: This appliance has been approved for 0” spacing to adjacent surfaces above the cooktop.However, a 6” minimum spacing to surfaces less than 15” above the cooktop and adjacentcabinet is recommended to reduce exposure to steam, grease splatter and heat.Installation Information: Before installing, consult installation instructions for currentdimensional data and additional requirements.MINIMUM DIMENSIONS BETWEEN COOKTOP, WALLS AND ABOVE THE COOKTOP:A. Make sure the wall covering, countertop, flooring and cabinets around the range carange.B. Allow 30" minimum clearance between surface units and bottom of unprotected wbottom of wood or metal cabinet is protected by no less than 1/4" thick flame retardansheet metal, (.015"), .015" thick stainless steel, .024" aluminum or .020” copper. Acceptabso the length is parallel to floor.C. This appliance has been approved for 0" spacing to adjacent surfaces above the cooless than 15" above the cooktop and adjacent cabinet is recommended to reduce expoTo reduce the risk of burns or fire when reaching over hot surface elements, cabinet stocabinet storage space is to be provided above the cooktop, the risk can be reduced bybeyond the front of the cabinets.PHS920SF/PS920SFANOTE CBACBothSidesNOTE: Use a 4' power cord to prevent interferencewith unit when installing.MINIMUM DIMENSIONS BETWEEN COOKTOP, WALLS AND ABOVE THE COOKTOP:A. Make sure the wall covering, countertop, flooring and cabinets around the range can withstand the heat (up to 200°F) generated by therange.297⁄ 8”36”371 ⁄ 4”257⁄8”297⁄ 8” 311⁄ 4 ”48*Depth including door handle is approximately 28-7/8".*28 7⁄ 8 ”1⁄ 4”HS920SF/PS920SFANOTE CBACBothSidesNOTE: Use a 4' power cord to prevent interferencewith unit when installing.KW Rating240V 12.2208V 9.2Breaker Size240V 40 Amps †208V 40 Amps ††Note: Check local codes for required breaker size.*Depth including door handle is approximately 28-7/8".