GE Profile PHS925ST1SS Technical Service Manual

Also see for PHS925ST1SS: Owner's manual Installation instructions

– 40 –Oven Door Hinge ReceiverTo remove the hinge receiver on PHS925:1. Remove the side panel. (See Left Side Panel orRight Side Panel.)Note: In the following step, the procedures toremove the top brace from the left side or right sideof the range are similar.2. Remove the top brace. (See Bake Element, followsteps 3-10.)3. Remove the induction module air inlet vent, (leftside only). (See Bake Element.)4. Remove the cooling fan (right side only). (SeeCooling Fan and FAD (Fan Apparency Device). )5. Remove the two 1/4-in. hex-head screws andthe cooling blower support, (right side only).Note: Upon reassembly, ensure displaced insulationaround oven and components is returned to itsoriginal position.Right side hinge receiver shownHingeReceiverLower Heat Shield6. Lift and separate the induction module air inletvent (left side) or the cooling blower support(right side) from the air tunnel. Unhook thebottom of the air tunnel from the range frame.7. Move the lower heat shield to the back of therange, tuck the insulation, and then remove thetwo T-20 screws that attach the hinge receiverto the frame.To remove the lower oven door hinge receiver onPS978:1. Remove the side panel. (See Left Side Panel orRight Side Panel.)2. Remove the two T-15 torx screws that attachthe hinge receiver to the frame.To remove the upper oven door hinge receiver onPS978:1. Remove the side panel. (See Left Side Panel orRight Side Panel.)2. Extend hinge as shown below and remove thetwo T-15 torx screws that attach the hingereceiver to the frame.3. Pull hinge receiver toward the back of the range.