For answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center ® service,800.626.2000.PP942SMGE Profile™ 30" Built-In CleanDesign Electric Cooktop220587Listed byUnderwritersLaboratories†Note: Check local codes for required breaker sizeImportant: Requires a 5” free area betweenthe bottom of the cooktop to any combustiblematerial, i.e., shelving. Free area not requiredwhen installing wall oven underneath cooktop.Refer to installation instructions. Requires a15” minimum from cooktop to adjacentoverhead cabinets. Units are furnished witha 48” flexible armored cable.Note: 30” Ribbon cooktops are approved for use over select GE 30” SingleWall Ovens and Warming Drawers. All 30" ribbon cooktops can be installedover 27" wall ovens and warming drawers. Refer to cooktop and wall oven/warming drawer installation instructions packed with product for currentdimensional data. If installed with a GE Profile™ Telescopic Downdraft System,consult both the cooktop and downdraft installation instructions packedwith product before installing. Cooktop gas/electric supply may need to bere-routed to install downdraft. The countertop must be at least 26" deep witha flat surface area of 23-1/2" or more, front to back. In addition, otherclearances to the front edge of the countertop must be considered.Consult cabinet and countertop manufacturer’s specs for flush mountinstallation prior to install.Installation Information: Before installing, consult installation instructionspacked with product for current dimensional data.KW Rating240V 7.8208V 5.9Breaker Size240V 40 Amps†208V 30 Amps†3-1/4*Cooktop2-1/2**Required28-1/219-5/829-7/830_ss_cktp_install.eps21-1/2Electrical junction box 16" MIN.below countertop30" MIN. tounprotectedcabinetCut shouldnot interferewith cabinetstructureat front1-1/2" MIN.clearance toside wallfrom cut-out1-1/2" MIN.clearance toside wallfrom cut-out1-3/4" torear wall13" MAX.depth* Depth of unit at conduit connection location (rear) is6-1/2" on models PP980/950 and 4-5/8" on modelsPHP900/PP975/972/962/945/942/932/912,JP655/356/346.**Raised bull nose countertops may require up to3/8" additional clearance to prevent interferencewith curved front.15" MIN.to cabinetSpecification Revised 12/07Dimensions and Installation Information (in inches)