GE Profile PSCF3RGX Owner's Manual And Installation

Also see for 25: Owners and installation manual Owner's manual Owner's manual Use and care & installation guide Use and care & installation guide

Contents

About the automatic icemaker.Consumer Support Troubleshooting Tips Operating Instructions Safety InstructionsInstallationInstructions14Automatic IcemakerThe icemaker will produce seven cubesper cycle—approximately 100–130 cubesin a 24-hour period, depending on freezercompartment temperature, roomtemperature, number of door openingsand other use conditions.If the refrigerator is operated before thewater connection is made to the icemaker,set the power switch in the OFF position.When the refrigerator has been connectedto the water supply, set the power switch tothe ON position.The icemaker will fill with water when it coolsto 15°F (–10°C). A newly installed refrigeratormay take 12 to 24 hours to begin making icecubes.You will hear a buzzing sound each timethe icemaker fills with water.Throw away the first few batches of iceto allow the water line to clear.Be sure nothing interferes with the sweepof the feeler arm.When the bin fills to the level of the feelerarm, the icemaker will stop producing ice.It is normal for several cubes to be joinedtogether.If ice is not used frequently, old ice cubes willbecome cloudy, taste stale and shrink.Special note about dispenser models:■ Dispenser models have a tilt-out ice bin.The bin can be tilted out as shown inthe illustrations, and it will hold itself upwhile you take ice out or turn the icemakerpower switch on and off. Be sure to put thebin back in place before closing the door.■ To restore your ice level from an emptybucket stage, the following steps arerecommended:12 hours after the first batch of icehas fallen into the bin, dispense3 to 4 cubes.After an additional 6 hours, dispense3 to 4 cubes again.These steps will restore your ice levelin the shortest amount of time.NOTE: In homes with lower-than-averagewater pressure, you may hear the icemakercycle multiple times when making one batchof ice.A newly installed refrigerator may take 12 to 24 hours to begin making ice.Lift the bin, then pull itforward until the bin stops.Removing Ice Bin (dispenser models)CAUTION:The ice bin is heavywhen full.Set the power switch to the OFF positionbefore removing the bin.When replacing the bin, be sure to pressit firmly into place. If it does not go all theway back, remove it and rotate the drivemechanism 1/4 turn. Then push the binback again.Lower the bin to access iceor reach the power switch.NOTE: In order to take full advantageof the tilt-out ice bin, only store items onthe shelf below the ice bin that are notaller than the lowest point on the bin.On dispenser models,to access ice or reachthe power switch:Lift the bin, then pull itforward until the bin stops.Lift and pull forward againto remove the bin.RotateDriveMechanismDispenser Models onlyIcemakerFeeler ArmPower Switch