GE Profile PSSF3RGZ Owner's Manual And Installation

About the automatic icemaker.Consumer Support Troubleshooting Tips Operating Instructions Safety InstructionsInstallation Instructions14Automatic IcemakerThe icemaker will produce seven cubesper cycle—approximately 100–130 cubesin a 24-hour period, depending on freezercompartment temperature, room temperature,number of door openingsand other use conditions.If the refrigerator is operated before the waterconnection is made to the icemaker, set thepower switch in the OFF position.When the refrigerator has been connected tothe water supply, set the power switch to the ONposition.The icemaker will fill with water when itcools to 15°F (–10°C). A newly installedrefrigerator may take 12 to 24 hours to beginmaking ice cubes.You will hear a buzzing sound each timethe icemaker fills with water.Throw away the first few batches of ice to allowthe water line to clear.Be sure nothing interferes with the sweepof the feeler arm.When the bin fills to the level of the feeler arm,the icemaker will stop producingice. It is normal for several cubes to be joinedtogether.If ice is not used frequently, old ice cubes willbecome cloudy, taste stale and shrink.Special note about dispenser models: Dispenser models have a tilt-out ice bin. Thebin can be tilted out as shown in theillustrations, and it will hold itself up whileyou take ice out or turn the icemaker powerswitch on and off. Be sure to put the bin backin place before closing the door. To restore your ice level from an emptybucket stage, the following steps arerecommended:12 hours after the first batch of icehas fallen into the bin, dispense3 to 4 cubes.After an additional 6 hours, dispense3 to 4 cubes again.These steps will restore your ice levelin the shortest amount of time.A newly installed refrigerator may take 12 to 24 hours to begin making ice.Removing Ice Bin (dispenser models)CAUTION: The ice bin is heavy when full.Set the power switch to the OFF position beforeremoving the bin.When replacing the bin, be sure to press itfirmly into place. If it does not go all the wayback, remove it and rotate the drive mechanism1/4 turn. Then push the bin back again.IcemakerFeeler ArmPowerSwitchOn dispenser models,to access ice or reachthe power switch:RotateDriveMechanismDispenser Models onlyPull the bin forward until thebin stops.Lower the bin to access iceor reach the power switch.