GE Profile PSSF3RGZ Owner's Manual And Installation

Consumer Support Troubleshooting Tips Operating Instructions Safety InstructionsInstallation Instructions18Replacing the light bulbs.Setting the controls to OFF does not remove power to the light circuit.Reveal ® appliance bulbs are used on some models. They can be identified by their blue color when theyare not illuminated.Not all features are on all models.Refrigerator Compartment—Upper LightUnplug the refrigerator.The bulbs are located at the top of thecompartment, inside the light shield. Onsome models, a screw at the frontof the light shield will have to be removed.On other models, the screwis located in the pocket locatedat the back of the light shield.To remove the light shield, on somemodels, press in on the tabs on the sides ofthe shield and slide forward and out. Onother models, just slidethe shield forward and out.After replacing the bulb with an appliancebulb of the same or lower wattage, replacethe light shield and screws (on somemodels). When replacing the light shield,make sure that the tabs at the back of theshieldfit into the slots at the back of the lightshield housing.Plug the refrigerator back in.Refrigerator Compartment—Lower LightThis light is located above the top drawer.Unplug the refrigerator.Remove the convertible meat drawercontrol knob by pulling straight out.Lift the light shield up and pull it out.After replacing the bulb with an appliancebulb of the same or lower wattage, replacethe shield andthe knob.Plug the refrigerator back in.Freezer CompartmentUnplug the refrigerator.Remove the shelf just above the lightshield. (The shelf will be easier to remove ifit is emptied first.) On some models, ascrew at the top of the light shield will needto be removed.To remove the light shield, press inon the sides, and lift up and out.Replace the bulb with an appliance bulbof the same or lower wattage, andreinstall the light shield. Whenreinstalling the light shield, make surethe top tabs snap securelyinto place. Replace the screw(on some models).Reinstall the shelf and plug therefrigerator back in.COLDCOLDESTDispenser (on some models)Unplug the refrigerator.The bulb is located on the dispenser underthe control panel.Remove the light bulb by turningit counterclockwise.Replace the bulb with a bulb of thesame size and wattage.Plug the refrigerator back in.TabsPocketORYour light shield will look likeone of the following: