GE Profile PTDN850GM0WW Owner's Manual And Installation Instructions

Contents

Dryer Features. GEAppliances.comDuct SensingThe duct blockage system automaticallymonitors, detects and alerts you to blockagesin the ductwork. Blocked ductwork candegrade dryer performance by reducingairflow from the dryer. If you observe thedisplay window with the message, "CLg" it istime to clean your exhaust ducting in order toincrease efficiency and reduce dry times.Screw Changing the Drum LampBefore replacing the drum lamp, be sure tounplug the dryer power cord or disconnectthe dryer at the household distribution panelby removing the fuse or switching off thecircuit breaker.The drum lamp is located at the top left ofthe door frame.1 Removethe screw holding the drum lumpshield in place.2 Slide the shield up and remove.21 Removethe bulb and replace with aiS-watt, 120-volt candelabra-base bulb.4 Replacethe lump shield and screw.Using the Drying RackA handy drying rack may be used for dryingdelicate items such us washable sweaters.Hook the rack over the lint filter so the rackextends into the dryer drum.NOTE:The drying rack should only be used withthe TIMEDRYcycle. It is also stronglyrecommended when drying sneakers.Do not use this drying rack when there areother clothes in the dryer.Using the Steam CyclesAdd WaterBefore using a Steam Cycle,the water tankmust be filled with water up to the MAXline.If not, the ADD WATERlight will blink. Makesure that the water tank is filled with waterand the cartridge is completely connected.Turn the dryer off and then restart the SteamCycle.1. Turn the dryer off by pressing the POWERbutton.2. Open the lid.21.Move the lever to open.4. Lift out the water tank and open the tanklid.5. Fillthe tank to the HAX water line withwater.6. Placethe water tank back into the barreland move the lever to close.7. Close the lid, press the POWERbutton andselect the cycles desired.NOTES+Only use water. Do not fill the water tankwith foreign substances, rinse agents, ordetergents.+Before moving the dryer, make sure thewater tank is empty.Do not use distilled water; the water levelsensor in the steam generator will not work.+Be careful while filling the water tank toavoid overflow and spilling.+Wipe up any spilled water around the watertank and the drawer before starting thedryer.11