GE Range Installation Instructions Manual

Also see for Monogram ZDP304L: Owner's manual Installation instructions Owner's manual Installation instructions

GE Range Installation Instructions Manual Manual pdf 15 page image

15REPLACE OVEN DOOR(S)Skip this step if oven doors are in place.IMPORTANT: Do not lift the door by the handle.To replace the oven doors:•Firmly grasp the door at the top sides.This is critical.•Approach the range with the door angledin a vertical position.•Guide the hinges into the slots.•Push the door in firmly while opening.•Once in position, open the door completely.Push the hinge locks back in and towardthe front frame.CAUTION: Take care when replacingthe oven doors. If the hinge latch is not securelylocked, the hinge may snap back and separate.If the hinge separates, you must apply pressure(possibly with your foot) to press it back togetherand then engage the hinge latch.STEP 8InstallationLEVEL THE RANGEWARNINGThe range must be level and be supportedby the legs—not the wheels. The range could moveif the wheels make contact with the floor. Be sure alllegs make contact with the floor in any installation.•All legs must be leveled after the product isinstalled.•Check to be sure the adjoining cabinets/countertops are level, front to back and leftto right across the opening of the range.•Measure the distance from the floor to the topof the countertop in the left and right rear corners.•Adjust the height of the range to countertop heightor higher.IMPORTANT: This range should always be installedat countertop height or higher. DO NOT INSTALLTHE RANGE LOWER THAN ADJACENT COUNTERTOPHEIGHT. The range must be supported by all 4 legs,regardless of countertop height.FRONT LEG ADJUSTMENT•Slide front cylinders up to adjust front levelinglegs. Be careful not to damage cylinder.•A leveling leg wrench is supplied. Reach underthe front of the range near the right side. Locateand remove a thumb screw, then slide wrench outof the slot.STEP 7Rear LegExtension RodRear Vent TrimREAR LEG ADJUSTMENT•Remove two screws from rear vent trim. Slide venttrim forward, then lift up to remove.•Find the two rear leg extension rods. Use a 1/4"driver or wrench to adjust the left or right rear legs.•Use the supplied wrench to turn the front levelinglegs. Turn clockwise to raise the range above thewheels. Turn counterclockwise to lower the legs.•Be sure to return the wrench to its storage slotfor future use.Slide legcylinder up.Thumb ScrewLEVEL THE RANGE (cont.)STEP 7•Replace the rear vent trim using the original screws.