For answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center® service,800.626.2000.SCB1001MSSGE Profile Advantium® 120 Wall OvenAdvantium wall oven/GE Profile cooking tower dimensions and cabinet installation information (in inches)Note: Cabinetsinstalled adjacentto wall ovens musthave an adhesionspec of at least a194°F temperaturerating.Note: 2" minimumbetween cutoutswhen installedabove warmingdrawer or singlewall oven.InstallationInformation:Before installing,consult installationinstructions packedwith product for currentdimensional data.Specification Created 9/06 240405CabinetWidthWWidthHHeightDDepth(excludinghandle)XCutoutWidthYCutoutHeightZCutoutDepthminimumSCB1000/1:27" Installationwithout trim kit 27 26-3/4 19-1/32 21-1/2 25-1/8 17-1/2 23-1/2SCB1000/1:30" Installationwith trim kit 30 29-3/4 19-1/32 21-1/2 25-1/8 17-1/2 23-1/2Listed byUnderwritersLaboratoriesantium_Install_dim.epsCutout widthXCabinet widthRequiredcutout location36-3/4"minimumfrom floorJunctionboxlocationA=Allow 1" overlap of oven over top and bottom edges of cutout.B=Allow 11/16"-3/4" for overlap of oven over side edges of cutout.4-3/16YCutout heightA BZCutout depthWHantium Wall Oven Dimensions (in inches)andinet Installation (in inches)Cabinets installed adjacentl ovens must have an adhesionf at least 194° F temperature rating.Construct SolidBottom Min.3/8" PlywoodSupported by2 x 4 or 1 x 2Runners, allFour Sides.(Must Support150 lbs.)Conduit(48-1/2"long)D1" Min. above toekick or adjustto oven installation height2" MIN between cutouts2-1/2" MIN between cutoutsrecommended—2" MIN required9-1/4" cutout height28-1/2" cutout widthJunction box locationA BA B Construct Solid BottomMIN 3/8" Plywood Supported by2 x 4 or 1 x 2 Runners, all Four Sides.(Must Support 150 lbs. for Advantium)(Must Support 200 lbs. for Wall Oven)4-3/16DExcludingHandleHWadv_240_120_cooktower_dia.epsConduit(46" long)Cabinet widthCL(Must Support 275 LBS.)cooking_tower_solid_floor.eps2 x 4’s orequivalentsolid floorSuitablebracingto supportrunners21-5/8"over centerlineof cabinetA=Allow 1” overlap of oven over top and bottom edges of cutout.B=Allow 11/16”-3/4” for overlap of oven over side edges of cutout.A=Allow 1” overlap of oven over top and bottom edges of cutout.B=Allow 11/16”-3/4” for overlap of oven over side edges of cutout.