GE SG 225 User Manual

Also see for SG Series: Installation guide Datasheet Use and care manual Installation guide User manual

Modifications reserved Page 38/79OPM_SGS_USM_M22_M30_2US_V010.doc User Manual SG Series 225 & 300 UL S2`Home\SetupSETUPLEVEL 1 : USERLEVEL 2 : SERVICEV Setup screenLEVEL 1 USERDisplays a sequence of screens with parameters which canbe user defined.LEVEL 2 SERVICEOnly service is allowed.At this level the parameters access is protected by a code.`Home\Setup\UserDATE AND TIMED M YDate : 15.05.2010H M STime 15:37:25VDate and time screenDate You can adjust the date of the real time clockexisting in the UPS by the means of this parameter.The value you enter is thoroughly checked to be acorrect date in the format “DD.MM.YY”.Hour You can adjust the time of the real time clockexisting in the UPS by means of this parameter.The value you enter is thoroughly checked to be acorrect time in the format “HH.MM.SS”.The time is specified in 24-hour format.`Home\Setup\UserMODEMEnabled : NInit : BEQV1X3&D0S0=2Alarm call : NDelay : 30 secTel 1 : 1Tel 1 enabled : NVModem screen 1EnabledYou can enable/disable with Y/N the remote controlthrough modem calls by using this parameter.For modem connection, the default setting is for serial portJ3 on Customer Interface.InitThis parameter presents the modem initialization string.It can be 40 characters long.When editing this parameter the UPS considers that a blank character terminates the string.If no blank character is found then all 40 characters are used.Alarm callThis Y/N parameter controls the automatic events signaling through modem.If this parameter is set to Y (Yes) the UPS itself will call the remote location when a new event occursDelayThis parameter controls the delay between the occurrence of a new event and the modem dialing.It is useful because since the events typically do not occur isolated but in certain sequences, you can eliminatethe need for multiple dial-outs for such a sequence of events.Tel 1This parameter specifies a first telephone number to be used for modem dial-out.The telephone number has a maximum 40 characters and cannot contain blanks.If the desired number is shorter than 40 characters, the string will finish with blanks.Tel 1 enabledThis parameter Y/N specifies if the first telephone number (Tel 1) will be used for dial-out.