GE Self-Cleaning Electric Range Use And Care & Installation Manual

Also see for JBP21: Owner's manual Owner's manual and installation instructions Specifications Owner's manual and installation instructions Owner's manual and installation instructions

GE Self-Cleaning Electric Range Use And Care & Installation Manual Manual pdf 30 page image

BEFORE YOU BEGINRead these instructions completelyand carefully.IMPORTANT: Save these instructions forthe local electrical inspector’s use.IMPORTANT: OBSERVE ALL GOVERNINGCODES AND ORDINANCES.NOTE TO INSTALLER: Leave theseinstructions with the appliance afterinstallation is completed.NOTE TO CONSUMER: Keep this Use andCare Guide and Installation Instructions forfuture use.NOTE: This appliance must be properlygrounded.INSTALLATION INSTRUCTIONSSTEP 1PREPARE THE OPENING11⁄2″ spacing is recommended from the range toadjacent vertical walls above cooktop surface.Allow 30″ minimum clearance between surfaceunits and bottom of unprotected wood or metaltop cabinet, and 15″ minimum betweencountertop and adjacent cabinet bottom.EXCEPTION: Installation of a listed microwaveoven or cooking appliance over the cooktop shallconform to the installation instructions packedwith that appliance.To eliminate the risk of burns or fire by reachingover heated surface units, cabinet storage spaceabove the surface units should be avoided. Ifcabinet storage is to be provided, the risk can bereduced by installing a range hood that projectshorizontally a min. of 5″ beyond the bottom ofthe cabinets. Make sure the wall coverings,countertops and cabinets around the range canwithstand heat generated by the range, oven orcooktop up to 200°F.TOOLS YOU WILL NEED• Large blade screwdriver• Channel lock pliers or small ratchet wrenchwith 3/16″ socket (for leveling range)• 1/4″ hex head nutdriverELECTRICAL REQUIREMENTSCAUTION, FOR PERSONAL SAFETY:DO NOT USE AN EXTENSION CORD WITHTHIS APPLIANCE.REMOVE HOUSE FUSE OR OPENCIRCUIT BREAKER BEFORE BEGINNINGINSTALLATION.This appliance must be supplied with the propervoltage and frequency, and connected to anindividual, properly grounded branch circuit,protected by a circuit breaker or time delay fuse, asnoted on the rating plate.Wiring must conform to National Electric Codes.If the electric service provided does not meet theabove specifications, it is recommended that alicensed electrician install an approved outlet.Because range terminals are not accessible afterrange is in position, flexible service conduit or cordmust be used.NOT LESS THANWIDTH OF RANGELOCATEOUTLET BOXWITHIN EITHERSHADED AREAINSTALLOUTLET BOXON EITHERSIDE OF COUTLETBOX5″ MIN.1 1⁄2″MIN.15″MIN.30″MIN.CORDWALLWALLHOODAnti-Tip Bracket(install in either rear corner)FLOOR7″71 ⁄ 2″31 ⁄ 2″71 ⁄ 2″21 ⁄ 4″5″14 5⁄ 8″C OF RANGEL L30