17STEP 4 INSTALLATION WITHHOUSEHOLD WATERFILTRATION SYSTEMSkip this step if you do not have a household waterfiltration systemIf the water supply to the refrigerator is from anyhousehold water filtration system, the filter cartridgeshould be removed. For better ice and waterperformance, remove the filter and install the filter bypassplug.STEP 5 INSTALL SIDE PANELSSkip this step when not using side panels.If you are using 1/4” side panels, they should beinserted into the case trim. Fasten the panels to therefrigerator with stick-on hook and loop fastener stripsbefore setting the refrigerator in place.STEP 6 INSTALL CASE TRIMInstall case trim using supplied right hand and left handcase trim pieces and case trim screws. Attach case trimto each side of case as shown in illustration using casetrim screws in holes provided down each side of case.STEP 7 ANIT-TIP PROCEDUREWARNING Tip Over Hazard.These refrigerators are top heavy, especiallywith any doors open, and must be secured toprevent tipping forward which could result indeath or serious injury. Read and follow theentire installation instructions for securing therefrigerator with the anti-tip system.AVERTISSEMENT Risque debasculementCes réfrigérateurs présentent une partiesupérieure lourde, en particulier avec une porteouverte; ils doivent donc être fixés pour prévenir lebasculement vers l’avant et le risque concomitantde blessure grave ou fatale. Lisez et suivezles instructions d’installation complètes pourl’installation du système anti-basculement.Flush Installation Only• Cut a 1/2” x 4” block, 35” long.• Measure and mark under the soffit, 5-1/4” from thefront edge of the cabinet.• Secure the wood block to under the soffit. Fromthe bottom of the block to the finished floor shouldmeasure 84”. See the illustration.Installation InstructionsFilter BypassPlugRotate Counterclockwise ToRemove