GE Side by Side Refrigerators Installation Instructions Manual

Also see for 36 Ceramic Cooktop: Owner's manual Owner's manual Use and care guide Use and care guide Owner's manual

GE Side by Side Refrigerators Installation Instructions Manual Manual pdf 22 page image

22Installation InstructionsSTEP 14 HANG DECORATIVE DOOR PANELS - FLUSH INSTALLATION ONLYPanels with attached brackets will mate with steelbrackets already attached to top, sides, and bottom ofrefrigerator doors. Each bracket attached to the doorwill have two machined screws recessed inside the doorto provide anchoring points for wood panel brackets toinstall onto the doors.1. Lift the Fresh Food door panel to hang the panel on thefresh food door. Angle the bottom of the panel slightlyaway from the fresh food door. The brackets mountedat the top of the door panel will lay over the top of thebrackets mounted at the top of the fresh food door.Allow the flanges of the door brackets to slide into theslot at the top of the panel brackets and gently allowthe bottom edge of the panel to lay against the freshfood door as it hangs freely.2. Repeat previous step with the freezer door panel. Thebrackets mounted at the top of the freezer door panelwill lay over the top of the bracket mounted on the topof the freezer door.3. Adjust the panels on each door by pushing it flushagainst the doors. Push each panel toward the center ofthe refrigerator so the panels are as close to touchingeach other as possible.4. Using supplied washer-head screws, secure panelbrackets mounted to the rear of the wooden panels tothe refrigerator door; top, side and bottom.Each screw should be tightened until snug, and thenbacked off 2-3 turns to allow for fine tuning adjustment.NOTE: If screws are fully tightened at this stage,further panel adjustment will not be possible.5. Thread set screws into each of the panel bracketsattached to the doors. Hinge side brackets will have 2set screws each, going into the door. The handle sidebrackets will each have 1 set screw going into the door.Each panel bracket has a tab that is aligned with a tabon the door bracket. Each of these will have a set screwthreaded into them (see illustration).