GE SimpliNano Original Instructions Manual

Also see for Ultrospec 7000: Operator's manual Installation and start-up manual

Contents

29-0047-78 AC 04-2014 51.5. General HazardsThere a number of warning labels and symbols that may be present on yourinstrument. These are there to inform you where a potential danger exists orparticular caution is required. Before commencing installation, please take time tofamiliarise yourself with these symbols and their meaning. This instrument is subjectto the following hazards:CAUTIONSome of the above instruments contain a UV source which generates a light beam that traverses the samplechamber and is accessible in the lamp chamber. Under normal use the lamp beam is confined within the instrument.The unit should not be operated with the sample chamber lid open or the lamp housing lid removed as prolongedexposure to the beam may cause permanent eye damage.(Not applicable to Ultrospec 10, Novaspec III/Plus)WARNINGHigh voltages exist inside the Ultrospec 2100/7000/8000/9000, GeneQuant 100/1300, SimpliNano and NanoVue Plusinstruments. Repair and maintenance should only be carried out by individuals trained specifically to work on theseinstruments.CAUTIONThese instruments may be connected to a separate PC. To preserve the integrity of the measuring equipment it isessential that the attached PC itself conforms to basic safety and EMC standards and is set up in accordance withthe manufacturers’ instructions. If in doubt consult the information that came with your PC. In common with allcomputer operation the following safety precautions are advised.• To reduce the chance of eye strain, set up the PC display with the correct viewing position, free from glare and withappropriate brightness and contrast settings.• To reduce the chance of cross contamination from biological samples, use appropriate personnel protectionmeasures and disinfectant wipes on keyboard and mouseCAUTION, HOT SURFACE• These instruments may be fitted with heated cell holder accessories that depending on operation may become hotto touch. Care should be taken to avoid touching the heated accessory when running at elevated temperatures1.6. Unpacking and installationNanoVue Plus instrument External power supply• Inspect the instrument for any signs of damage caused during transit. If anydamage is discovered, do not use the instrument and report the problem to yoursupplier.• Ensure your proposed installation site conforms to the environment conditions forsafe operation• Indoor use• 5 to 40°C