GE Spectra Series Installation Instructions Manual

Also see for Spectra Series: Installation instructions Installation instructions Installation instructions Installation instructions Installation instructions

g Spectra Series™ Power PanelboardsEquipment Grounds, Types AEG 10, 21, 21S, 31SInstallationWARNING: Danger of electrical shock or injury.Turn OFF power ahead of the panelboard orswitchboard before working inside theequipment or removing any component.Equipment is to be installed and maintained byproperly trained and qualified personnel only.See Figures 1 and 2 for illustrations of AEG10 and AEG21uninsulated equipment grounds and Figures 3 and 4 forillustrations of AEG21S and AEG31S insulated equipmentgrounds.1. Attach terminals to the straps as shown in theappropriate figure. Find the holes for mounting theequipment ground at the opposite end of the boxfrom where it is stamped Line. If the box is painted,scratch through the paint in the area where the strapis to contact the box. Mount the equipment groundwith the two 10-32 thread-forming screws providedand tighten to 25-30 in-lb.2. Remove the paper backing from the identificationlabel provided. Place the label below the equipmentground, approximately in the position shown.Figure 1. Equipment ground catalog number AEG10.Figure 2. Equipment ground catalog number AEG21.Figure 3. Equipment ground catalog number AEG21S.GEH5586 Installation Instructions R02MountingPositionsIdentificationLabelsMountingPositionsIdentificationLabelsMountingPositionsIdentificationLabels

/ 2

Related manuals for GE Spectra Series