GE UVW7301 Owner's Manual & Installation Instructions

49-7000197 Rev. 0 5ControlsUSING THE HOOD: Controls3 2 11. MEMORY/OFF: To set the memory:A. Press the MEMORY/OFF button.B. Set your desired fan and light settings.C. Press the MEMORY/OFF button again to savethese settings.With your desired settings in memory, press theMEMORY/OFF button to restore the fan and lightlevels to their saved settings. These settings willremain in memory until they are changed or loss ofpower occurs.To turn off the hood, press the MEMORY/OFF button.2. LIGHT: Press + or – to increase or decrease lightlevel to desired setting. There are 2 light levels (LOW,HIGH) and OFF. If you continue to press the + or –buttons, the light will cycle back through the settings.3. FAN. Press + or – to increase or decrease fan levelto your desired setting. There are 4 fan levels (LOW,MED, HIGH, BOOST) and OFF. If you continue topress the + or – buttons, the fan will cycle backthrough the settings.NOTE: There is an audible “beep” each time a buttonis pressed. This is normal.NOTE: The collars around the buttons will illuminatewhen pressed. This is normal. The collars willautomatically turn off if the hood is turned off.HEAT SENSOR:This hood is equipped with a heat sensor that will turnon the fan if excessive temperatures are detected (overÛ&Û) DERYHWKHFRRNLQJVXUIDFH7KHKRRGZLOOreturn to its normal operation once the heat sensorGHWHFWVWHPSHUDWXUHVEHORZÛ&Û)NOTE: If the hood is OFF or on LOW fan speed, theWHPSHUDWXUHVDERYHÛ&Û)DUHGHWHFWHGWKHQWKHfan will automatically adjust to MED speed. You mayadjust the fan speed to HIGH or BOOST, but you willnot be able to adjust the fan speed to LOW or OFF untilWHPSHUDWXUHVEHORZÛ&Û)DUHGHWHFWHGNOTE: The collars around the buttons may not illuminateif the heat sensor is activated. This is normal.