1DEH-158 Installation Instructions R04WavePro ™ Power Circuit BreakersKey Lock Mounting Accessory Kit for 3200-4000A SubstructureCat. No’s WPS32SUBSH1, WPS32SUBSH2, WPH32SUBSH1,WPH32SUBSH2, WPS40SUBSH1, and WPS40SUBSH2Fig. 1WPSKLMTG2:Item Qty Description1 1 Slide Assembly2 5 Tamper-resistant Screws (1/4-20 x .625)3 5 Flat Washer4 1 Mounting Plate5 7 Lock Washer6 2 Tamper-resistant Screws (1/4-20 x .500)7 1 Taptite8 1 Shim9 1 Pivot Bar AssemblyTable 1. List of parts included in the key lock mounting kitWPSKLMTG2.KIT CONTENTS (Cat. No. WPSKLMTG2)This kit shown above contains the retaining anglewith slide assembly, pivot bar assembly, mountingplate, and mounting hardware. This unit installs onthe left side of the substructure. Key lock isfurnished by the customer. See back of this sheetfor lock required. Installation requires 5/32” tamper-resistant hex wrench.INSTRUCTIONS1. Remove parts as shown in Fig. 1.2. Assemble the customer supplied key lock to themounting plate (item #4) using 2 tamper-resistant screws (item #6), lock washers (item#5), and flat washers (item #3) as shown in Fig.2.3. Mount the retaining angle with slide assembly(item #1) to left side of substructure reusing 3taptites as shown in Fig. 2. (Leave hardwareloose.)4. Attach key lock and mounting plate assembly tothe left side of the substructure using 3 tamper-resistant screws (item #2) and lock washers(item #5) as shown in Fig. 2. (Leave hardwareloose.)5. If needed, adjust fixed cam as shown in Fig. 3.Screws may need to be loosened and roll pinremoved in order to make adjustment. Torquehardware to 7-9 Ft-Lbs. Drill 0.1875 diameterhole through the fixed cam and side frame.Reuse and install roll pin.6. Insert pivot bar rivet into slide assembly slot andmount to left side of substructure using shim(item #8), 2 tamper resistant screws (Item #2),CAUTION: To avoid electrical hazard, make sureprimary and secondary circuits are not energizedwhile working in the compartment.