STEP 2 INSTALL CUSTOM 3/4″DOOR PANEL AND HANDLE(ZIFI240 and ZIBI240 models only)3/4″ Overlay Panel DimensionsModel ZIFI240 and ZIBI240 requirea field-installed overlay door panel.• The overlay panel must besecured to a 1/4″ thick backerpanel that slides into the trim.A .10″ thick spacer panel mustbe placed between the overlayand backer panel.• A custom handle of your choice,supplied by your cabinetmaker,must be installed on this overlay panel. Countersink allscrews into the backer panel. Screws cannot protrudefrom the backer panel.IMPORTANT NOTE: Maximum total weight for customdoor panel is 25 pounds.1/4"BackerPanelDoor.10 InchSpacerOverlayPanelABSpacer PanelBacker PanelOverlay Panel6STEP 2 INSTALL CUSTOM 3/4″ DOORPANEL AND HANDLE (CONT.)(ZIFI240 and ZIBI240 models only)Assemble overlay panelswith glue and screws.• Center spacer panel on thebacker panel, left to right andtop to bottom. Secure thepanels with glue.• Center the spacer/backerpanel on the overlay panel.Secure with glue and screws. Countersink all screwsinto the backer panel.Custom Panel Hinge Routing DimensionsUse a 3/4″ router bit to cut a notch into the back side ofthe assembled panel 3/8″ toward the front of the overlaypanel, 3/4″ deep and 7/8″ wide.Install custom door panel and handle:• Open door to 90°.• Remove 5 screws holding trim; lift off trim.Retain screws.STEP 1 REMOVE PACKAGINGAND INSTALLATION PARTS• Remove corner blocks and foam drawer stops.• Remove all packing material, tape and protectiveplastic coverings.• Remove the toekick attached to the back of the unit.• Remove the custom panel attached to the front ofthe unit.CAUTION: Small objects are a choke hazardfor children. Remove and discard any parts not used.ATTENTION : Les petits objets peuventétrangler les enfants. Il faut jeter toutes les pièces quine sont pas utilisées.3/4″ Overlay Panel Dimensions (in inches)A (Width) B (Height)1/4″ Backer 23-3/16″ 29-9/16″0.10″ Spacer 22-1/2″ 29-1/16″3/4″ Overlay 23-5/8″ 30″Installation InstructionsNOTE: Right hand modelsillustrated. Follow thesame instructions on theopposite side for left handfresh food door swingmodels ZIFI240 andZIFS240.3/8″7/8″3/4″Back sideof custompanel3/4″7/8″3/8″NOTE: Right hand modelsillustrated. Cut notches on theopposite side for left hand freshfood door swing modelsZIFI240 and ZIFS240.