STEP 6 SLIDE PRODUCT INTOTHE CUTOUTCAUTION: Do not push against the doorpanel with your knees. Do not push or lift the unit bythe door handle. Damage may occur!ATTENTION : Ne poussez jamaisle panneau de la porte avec vos genoux. Ne poussezjamais votre appareil ou ne le soulevez jamais parla poignée de porte. Vous pouvez l’endommager.• Open the door and gently push the unit back intothe opening with your hands against the sides.Be careful not to entangle power cord.• In a standard 24″ opening, the front face ofthe stainless steel door will be flush with adjacentcabinetry. A custom panel door may protrude1-3/4″ beyond the surrounding cabinets.• Check again to be sure the unit is level.• If the unit is installed under a countertop, adjustthe leveling legs until the unit is resting firmly againstthe underside of the countertop.• If alignment with adjacent cabinetry is an issue,use a shim to secure the unit against the undersideof the countertop.STEP 5 CONNECT POWER• Connect power cord plug to a properly groundedreceptacle.• Check to make sure power is on by opening the doorto see if interior light turns on.• Bar Refrigerator with Icemaker – The interior fan runsall the time except during defrost cycle when the dooris open.• Fresh-Food Refrigerator – The interior fan runsall the time except when the door is open.See the Owner’s Manual for further explanation of the fan.STEP 7 SET TEMPERATURECONTROLS• The temperature controls are preset. Refer tothe Owner’s Manual for more information. Allow12–24 hours for the temperature to stabilize.NOTE: The Fresh-Food Refrigerator or Bar Refrigerator withIcemaker operate very quietly. You may not notice the unitrunning, and when first installed, the fans and motor maynot come on immediately – this is normal. If the display islit and the light is working, the unit is operating.Installation Instructions8