GE ZlS360N Design & Installation Manual

Also see for Monogram ZIS360N: Service bulletin Installation instructions Design & installation guide Installation instructions

Contents

Installation InstructionsISTEP 51 LEVEL REFRIGERATORAll models have 4-point leveling. The thmt issupported by leveling legs, the rear is supported bya_!justable wheels. Both are accessible fl'om the fl'ontof the refligerator.• To level the back of the refligerator, turn the7/16" hex nut located above the fl'ont wheels. Turnclockwise to raise or com_terclockwise to lower therefl'igerator.• For fl'ont leveling, use a ]-1/4" open-end wrench.• A(!just height of refl'igerator to match installationcutout opening 83-1/2" to 84-1/2". The refligeratorshould be level and phunb with cabinetry.llIHex Nut Adjusts_/Rear Whei__egCAUTION:The rear leveling wheels and fl'ont leveling legs arelimited to a maximum height ac!justment of 1". If theinstallation requires more than 84-1/2" height, theinstaller should elew_te the refl'igerator on a sheetof pl}_vood or rtmners. Cabinetry trim could also beadded across the top of the opening to shorten theopening. If you attempt to raise the refrigeratormore thm_ 1", you will dmnage the front levelinglegs and the rear leveling wheels.PRUDENCEI.es roues de nivellement artiste et les pattes denivellement avant permettent un r_glage maximalde 25 mm (l po). Si l'ouverture pore" le r_fi'ig_ratem"a tree hauteur sup_rieure _'l 2,15 m (84-1/2 po),l'installatem" doit _lever le r_li'ig_ratem" sur unefeuille de contre-plaqu6 ou des glissi&res, ll est_galement possible d'ajouter des baguettes definition des placards sur le haut de l'ouverture afinde la r_duire. Lever le r&frig&rateur de plus de25 Inln (1 po) endommage les pattes de nivellementavant et les roues de _fivellement arri&re.I STEP 61 ALTERNATE ANTI-TIPPROCEDUREThe refrigerator must be secured to prevent tipping.The mlti-tip brackets cmmot be used on metal wallstuds. Use this Alternate Procedure to secure therefrigerator against tip-over whenever metal wall studsare encountered mad there is no soffit.Side ViewTop CaseTrimi i =! ! !Install Four1-1/2" DrywallScrewsThroughTrimand IntoSoffitor 3/4" Min. Wood Brace• Raise the grille panel to access case trim.• Use a 3/16" bit to drill tour evenly spaced clearanceholes through the metal top case trim.• Use a 1/16" bit to drill to pilot holes through themetal clearance holes and into the wood sottit, Theholes should be centered in the sottit or a 3/4" rain.wood brace. The brace spanning the enclosm'e m ustbe secm'elv tastened to cabinets on both sides.• Install flmr, 1-1/2" drywall screws into the pilot holes.13