GE iBox Installation And Maintenance Manual

Contents

GE Grid Solutions iBox/iBox KitInstallation and Maintenance GuideGE Information 994-0047-5.10-4 57Digital Output Verification Test, continuedProcedure: Testing Digital Outputs, continuedStep Action7 Press the SPACE BAR to select Pulse, and press ENTER.8 In the Off time field, type 500 and press ENTER.9 In the On time field, type 500 and press ENTER.10 In the Repeat Command field, type 10 and press ENTER twice.Result: Listen carefully for an audible click of the point relay. A test isconsidered successful if the relays click when forced.11 For testing Trip/Close type operation, repeat steps 1- 6.12 Press the SPACE BAR to select Trip/Close, and press ENTER.13 In the Off time field, type 300 and press ENTER.14 In the On time field, type 300 and press ENTER.15 In the Repeat Command field, type the value 0 and press ENTER twice.Result: Listen carefully for an audible click of the point relay. A test isconsidered successful if the relays click when forced.Note: For Trip/Close operation in Repeat Command field, if fieldinput value is other than zero it results in a WIN write requestfailed error message with status 0x0011 (operation not supportedfor this point).Refer to Appendix G: Error Messages.Notes Note: The password shown above is factory default. If you cannot log in, contactyour system administrator to obtain the new password.Note: The number of times that a control will operate is actually N+1, where N isthe number of repeats entered in the Repeat command field. For a singleoperation, with no repeats, type 0. For two operations, type 1.Test Failure If relays do not operate:1. Ensure that the CONTROLS enable jumper is in the REMOTE position. Noerror message appears in WESMAINT if the test fails2. Reboot the iBox, and repeat the procedure3. Call GE Digital Energy for assistanceRepeat Test To repeat the test sequence, press CTRL+ U, and then press ENTER.Values entered for the previous test are retained until you exit the menu.Test NextPointTo test another point, use the UP or DOWN arrows to cycle through points, then pressCTRL+ U to repeat the test.