Gaggenau EB 388 Instruction Manual

Also see for EB 388: Assembly instructions Operating instructions

14End of cooking timeWith this function you can move the end of the setcooking time to a later point in time.To do this, enter the cooking time and program therequired time for the end of the cooking time. Theelectronic circuitry calculated the correspondingstarting time and starts cooking automatically.Note: note that easily perishable foodstuffs must notbe left in the oven for too long.Proceed as follows:1 Set a cooking time (see section entitled "Cookingtime")2 Press the M key twice. The × and Ò symbolsflash. The time display shows ¬¬:¬¬ or thecurrent duration.3 Set the required time with the aid of the @ and Akeys.4 Press the start key ~. The × symbol goes off andthe Ò lights up continuously.After expiry of the duration:The Ò flashes. An audible signal is sounded. Theappliance ends heating. Press any key. The Ò symbolgoes off, the signal tone goes off and heating isstarted again. Now set the temperature control to0° C.Note: you can even program the switch-off time if youhave not set a cooking time. Simply begin at point 2.TimerYou can use the timer to program a period of time,e.g. as an egg timer. You can enter values between00:01 seconds and 23:50 hours.1 Press the @ key. The y and V symbols flash.The time display shows ¬¬:¬¬ or the currentduration.2 Set the required duration with @ and A.3 Press the ~ key. The V symbol and the elapsingtimer are shown in the display.The timer starts, even without pressing the ~ key,if you do not enter anything for 5 seconds.After expiry of the duration:the V flashes. An audible signal is sounded. Pressany key to end the timer.Note: while the set timer is running, you can view thetime of the day by pressing the ~ key.Alarm clock functionA signal tone can be triggered at any time of the day.The alarm clock function is independent of the otherappliance functions.Note: the alarm clock function does not switch offyour appliance.1 Press the M key three times. The y and Usymbols flash. The time display shows ¬¬:¬¬ orthe current duration.2 Set the required time with the aid of the @ and Akeys.3 Press the start key ~. The y symbol goes off andthe U lights up continuously.After expiry of the duration:The U symbol flashes. An audible signal is sounded.Press any key. U goes off and the signal tone isended.StopwatchYou can use the stopwatch to monitor the cookingtime of dishes without programming automaticdeactivation, for example.The time is displayed beginning at 00:00 andextending up to a maximum of 12 hours.Switching the stopwatch on and off:You start or switch off the stopwatch by pressing theA key.