152. Attaching an alternative anti-tipdeviceImportant note:If the anti-tip brackets cannot be attached securely,an alternative anti-tip-device can be attached. However,ensure that there is no play between the appliance andthe anti-tip-device. If possible, always screw the woodenbeam to existing studs on the rear panel of theinstallation niche.1. Saw the wooden beam (cross section min. 3" x 4")to the required length. Length is equal to the widthof the installation niche!Note:– If the installation niche is deeper than theappliance, select a beam which has a largercross section or attach 2 beams.– The beam must cover the appliance byat least 2" (50.8 mm).2. Mark the installation height (lower edge of the beam)on the rear panel of the installation niche.3. Select screws according to the thickness of thewooden beam: length = min. 2.5 x beam thickness,diameter #12 or #14.Note:Choose the number of screws according to theinstallation niche width, thereby ensuring that thebeam can be attached securely.4. Depending to the subsurface:Locate wall studs in the rear of the installation nicheand accordingly transfer their location to the woodenbeamorfasten suitable dowel into the rear wall.5. Predrill the wooden beam.6. Attach the wooden beam to the rear panel of theinstallation niche.3. Attaching the edge protectorsTo protect the edges of the installation niche, it isrecommended to attach edge protection made ofa suitable material.Attach the edge protection with the adhesive tape whichwas used to attach the accessories to the appliance.4. Attaching the fastening sheets(lateral)Attach the fastening sheets (lateral) to the appliance.The following are special installationsteps. Instructions are provided aftersection D.– Change over door hinge, see“Changing over the door hinges”.– Side-by-Side installation, see “Side-by-Side installation”.– Connecting the water, see “Preparingto connect the water”.
