Gaggenau RB491200 Manual
Also see for RB491200 - annexe 2: Installation instructionInstallation instruction
                          | |
Contents
| 
20Base area/Crown of the niche10218172 - 106Base area CrownThe height of the cabinet door on the appliance isdependent on:– the overall height of the appliance,– the distance from the bottom edge of the cabinetdoor to the floor,– the appliance type (one-door or multi-door appli-ances).The overall height of the appliance is 2,134 mm.The height can be adjusted within a range of-13 mm to +35 mm.You must observe the minimum distance of 100 mmbetween the upper edge of the floor and the bot-tom edge of the cabinet door of the appliance.This height can vary depending on the conditionsat the site.It is possible, e.g. for design reasons, to lengthenthe cabinet door upwards by extending it beyondthe top of the appliance.For design reasons, it may be necessary to in-crease the distance between the upper edge of thefloor and the bottom edge of the cabinet door ofthe appliance, so that it extends beyond the stan-dard dimension of 102 mm. The maximum dimen-sion is 181 mm.If this is the case, air inlets and exhaust air outletsand access to the water filter would become visi-ble.It must be ensured that the crown of the instal-lation niche always has a depth of at least100 mm (measured from the front edge of theappliance). Only then can the secure installationof the appliance in the installation niche beguaranteed.G Important!Poor ventilation leads to damage to the appliance.Under no circumstances is it permitted to cover theair inlets and the exhaust air outlets of the appli-ance in the lower base area.You must observe the minimum distance of 100 mmbetween the upper edge of the floor and the bot-tom edge of the cabinet door of the appliance.Take this into consideration when adjusting theappliance feet also.102Cabinet door ofthe appliancePlinth33102Extending thecabinet doorCrownCabinet door ofthe appliance Appliancedoor Appliance bodyIn relation to the standard height, the maximumheight of the base board is 102 mm. The plinth canbe maximum 19 mm thick.Adhesive connectors are supplied on the frontpanel of the appliance for fitting the base board.The air inlets and the exhaust air outlets of theappliance, as well as the access to the water filter(if available) are located above the base board.They must not be covered. |
Related manuals for Gaggenau RB491200 - annexe 2
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine